Universal Remote Control MRF-300/RFX150 Frequently Asked Questions, Warranty, Specifications

Page 15

MRF-300 BASE STATION

Frequently Asked Questions

Can I use flasher/emitters that I have already installed in the system to connect to the MRF-300?

Yes, the flashers are compatible if they use 3.5mm mono mini plugs with the same polarity (Tip is data, sleeve is ground).

I am getting inconsistent operation regardless of flasher level or position.

Some components are easily overloaded with IR from nearby flashers. Prevent IR from affecting the problem component from other flashers or the front panel blaster by set- ting the device to a specific IR Line Output instead of ALL, then adjust the Line Output.

I have a row of identical TV’s. I’ve correctly set the flasher outputs using the Editor software, yet when I send a command to one of them, the TV next to the selected TV also responds. How do I stop this?

First, check the RF ID#, if the RF ID# is set to 0, IR routing does NOT work.The RF ID# from 1-9 or A-F must be set on both the remote control and the bottom of the MRF-300. Second, check that an opaque material like electrical tape is used to cover the flasher and the front panel sensor of each of the TV’s. Sometimes several layers are necessary.

How can I increase the range of the remote control?

Often, you can increase range by adjusting the range screw and/or repositioning the RFX-150. If you still can’t get the range you need, consider installing additional

RFX-150 RF Sensors in the areas with poor range by concealing wire runs to nearby attic or crawl space locations.

Warranty

The MRF-300 is covered against any manufacturers defects or workmanship for a period of one year from the date of purchase if purchased from an authorized Universal Remote Control dealer. Units purchased from online auc- tion sites or other unauthorized resellers have no warranty.This warranty does not cover the following items:

-Damage from misuse, neglect, or acts of nature.

-Products that have been modified or incorporated into other products. -Products purchased more than 12 months ago.

-Units purchased from unauthorized dealers or companies.

Specifications

Power Supply: 9V 300mA

IR Flasher Line Outputs: 3.5mm Mono Mini Jack

RF Frequency: 418MHz

Size: 8” x 3.5” x 1.25”

Page 12

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Installation Manual Page Table of Contents Introduction IR Input for Keypads or IR Repeater Systems Features and BenefitsInterference Rejection and Adjustable RF Range via RFX-150 Parts GuideInstallation Connect the RFX-150 to the RF IN, but do not Mount IT Daisy Chain Multiple MRF-300’s to One RFX-150 RF SensorMount the RFX-150 and adjust for Optimum Range Connect the Power Supply to the MRF-300Test RF Address Adjust IR Line Output LevelsOpen the RF Setup Window Front Blaster OverloadDisabling the Front Blaster Step by Step via PC Program One Device With IR commands Controlling An Array of Identical Components or ZonesIdentical Components/Zones Step by Step via PC Adjust the Signal For Each of the Identical Devices Copy The Programmed Device Paste The Programmed Device Click on the cell for the first Add, Name and Assign Receiver ID# Open the RF Setup Window in MX EditorReveal the Receiver settings Programming For Multiple Equipment LocationsHow can I increase the range of the remote control? Frequently Asked QuestionsWarranty SpecificationsComplete ControlTM
Top Page Image Contents