Universal Remote Control MRF-300/RFX150 Front Blaster Overload, Open the RF Setup Window

Page 10

MRF-300 BASE STATION

Front Blaster Overload

A few models of audio/video components can be OVERLOADED by the Front Blaster. If you are having intermittent or inconsistent results with a particular component, try repositioning the MRF-300 and facing the Front Blaster in a different direction. If this improves the situation but is impractical, it may be necessary to utilize the self-adhesive flashers only and follow the steps below to Disable the Front Blaster. This will limit the number of components your MRF-300 can control to six. If you have more than six components you can purchase an additional MRF-300.

Disabling the Front Blaster - Step by Step via PC

Note: If you are programming a URC MX “addressable” remote control that sets up without a PC, refer to the owners manual to disable the Front Blaster.

Open the PC software, then plug the MX PC programmable remote control into the PC. Open your saved configuration and follow these steps to turn off the front blaster:

Step 1 - Open the RF Setup Window

The RF Setup window opens after selecting RF

Control from the Program Menu.

Step 2 - Setup the Receiver Extend the RF Setup window by click- ing on the Receivers button.

Step 3 - Turn off the Front Blaster Click on the cell in the IR LED OUTPUT/IR BLASTER column. A list box will appear. Select OFF from the list.

Next, click on OK to apply your change.

SAVE your changes using FileSave and DOWNLOAD to the remote control.

Page 7

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Installation Manual Page Table of Contents Introduction Parts Guide Features and BenefitsInterference Rejection and Adjustable RF Range via RFX-150 IR Input for Keypads or IR Repeater SystemsInstallation Daisy Chain Multiple MRF-300’s to One RFX-150 RF Sensor Connect the RFX-150 to the RF IN, but do not Mount ITConnect the Power Supply to the MRF-300 Mount the RFX-150 and adjust for Optimum RangeAdjust IR Line Output Levels Test RF AddressFront Blaster Overload Open the RF Setup WindowDisabling the Front Blaster Step by Step via PC Controlling An Array of Identical Components or Zones Program One Device With IR commandsIdentical Components/Zones Step by Step via PC Copy The Programmed Device Adjust the Signal For Each of the Identical DevicesPaste The Programmed Device Click on the cell for the first Programming For Multiple Equipment Locations Open the RF Setup Window in MX EditorReveal the Receiver settings Add, Name and Assign Receiver ID#Specifications Frequently Asked QuestionsWarranty How can I increase the range of the remote control?Complete ControlTM
Top Page Image Contents