Toshiba P503DL service manual Input Signal selection

This remote control is compatible for most of Toshiba data-wall display cube.

The GUI of cube commander is also similar layout of the push buttons so that once the position of these key pads are getting familiar, both can be used without any difficulty.

Difference between this remote control and software is, the ID number access, this is caused by the command generation CPU, in a PC which the software is installed or use the CPU in the cube.

stand-by mode

Power

ID mode

ID.ALL

ID.SEL

ID.SET

ID.CLR

Adjust

ßà normal mode ßà Power

Digital

Video1

RGB1

RGB2 White Balance

Adjust Call

STD

*MODE (0-9) (Mag. Memory)

adjust mode ßà special mode

Cut -off		1: Auto-Adj on-off
Drive	7: Picture in Picture
Gain	8, A, B, C: OSD color
Off-set		9: Power Delay time
Contrast	D: Firmware Version
Brightness	E: Lamp Timer History
Color	F: Current Lamp timer
Tint
Sharpness
Phase	ßà	service mode
Clock		0:
Capture		1: OSD Mute

*MODE button makes to recall Magnification memorized at

0-9 memory positions (ref P36)

This chart is indicating the functions and also which button can be selected.

Magnification	2: Screen mode Lock
Layout	4: Picture smoothing filter
Position	C:
Test pattern
Mode

Flip

Call

7: Color Mix (color coordinate) 4=R, 5=G, 6=B

ADJUSTMENT

3-1. Input Signal selection

Sources are selected by pressing the relevant source button: RGB1RGB2 or VIDEO. To select and display video picture, the video input adaptor need to be installed.

The screen will mute for approximately 5-7 seconds following source selection. Source sele ction is basically possible in Normal Mode.

27