GE IC697VAL348 Physical Installation, Do not install or remove boards while power is applied

Page 9

2

Physical Installation

Caution

Do not install or remove boards while power is applied.

To install the board, de-energize the equipment and insert the board into an appropriate slot of the chassis while ensuring that the board is properly aligned and oriented in the supporting card guides. Slide the board smoothly forward against the mating connector until firmly seated. Review “Configuration” on page 2-3 and “Before Applying Power: Checklist” on page 2-4 before operating the board.

2-2	IC697VAL348 8-Channel, 16-bit Digital-to-Analog Converter Board User’s Manual	GFK-2059
	– December 2001

Image 9

Contents GE Fanuc Automation Cimstar As Used in this PublicationContents Reference Material and Other GE Fanuc Manuals Introduction, Description, and SpecificationsGeneral Description Functional Description Ground the System Safety SummaryConfiguration and Installation Do not install or remove boards while power is applied Physical InstallationJumper Function Preset Condition ConfigurationDigital-to-Analog Converter Board Installation Before Applying Power ChecklistRead this Direction OFF, Open = ON, Closed = Board Address Selection SwitchesAddress Modifier Address Modifier Response Selection JA Offset Binary TWO’S Complement Code Digital Code SelectionProgram Controlled and External Start Convert Mode Connector Descriptions Rear View of Board PC Board Pin Number Row a Signal Mnemonic P2 ConnectorRow B Signal Mnemonic Row C Signal MnemonicPC Board Row B Signal Mnemonic Row C P3 ConnectorDAC Zero Offset and Gain Calibration P3 ConnectorDigital-to-Analog Converter Board Calibration Table Channel Offest PotSide Programming DAC Channels Address Map 1Control and Status RegisterDAC Channels 0 to 7 Address Write Only D15 MSB D00 LSBDigital-to-Analog Converter Board Programming Options Immediate DAC Update ModeControl Register Data Format and Definitions D09 D08 Delayed DAC Update Mode Test Mode Programming Program Example Delayed DAC Update Mode END Analog Output Control in Immediate DAC Update Mode Analog Out PathwayControl Word D15 to D0 Hex Value DAC Programming Sequence Delayed DAC Update Mode Analog Output Control in Delayed DAC Update Mode Theory of Operation Operational Overview Immediate DAC Update Mode Program Control Update Mode Digital-to-Analog Converter Board Functional Block Diagram VMEbus Interface Description A01 A02 A03 A04 VMEbus Interface Logic and Interface Signals DIG GND Maintenance