GE IC697VAL348 user manual Program Controlled and External Start Convert Mode

Page 16

2

Program Controlled and External Start Convert Mode

The PROGRAM CONTROLLED START CONVERT MODE is enabled by inserting jumper JD. This mode is detailed in “Program Control Update Mode” on page 4-4 and “Delayed DAC Update Mode” on page 3-6. With no jumper installed at JD, the board operates in the IMMEDIATE DAC UPDATE MODE as described in “Immediate DAC Update Mode” on page 4-3 and “Immediate DAC Update Mode” on page 3-3.

Installing jumper JE enables the EXTERNAL START CONVERT MODE. Jumper JD must also be installed (refer to “External Trigger Update Mode” on page 4-4). The external trigger is buffered in through the P2 connector pin A25 with an associated digital ground wire at pin A26. The locations of jumpers JD and JE are shown in Figure 2-2 on page 2-6.

GFK-2059

Chapter 2 Configuration and Installation

2-9

Image 16

Contents GE Fanuc Automation As Used in this Publication CimstarContents Introduction, Description, and Specifications Reference Material and Other GE Fanuc ManualsGeneral Description Functional Description Safety Summary Ground the SystemConfiguration and Installation Physical Installation Do not install or remove boards while power is appliedConfiguration Jumper Function Preset ConditionBefore Applying Power Checklist Digital-to-Analog Converter Board InstallationBoard Address Selection Switches Read this Direction OFF, Open = ON, Closed =Address Modifier Address Modifier Response Selection Digital Code Selection JA Offset Binary TWO’S Complement CodeProgram Controlled and External Start Convert Mode Connector Descriptions Rear View of Board PC Board P2 Connector Pin Number Row a Signal MnemonicRow B Signal Mnemonic Row C Signal MnemonicPC Board P3 Connector Row B Signal Mnemonic Row CP3 Connector DAC Zero Offset and Gain CalibrationDigital-to-Analog Converter Board Calibration Table Channel Offest PotSide Programming 1Control and Status Register DAC Channels Address MapDAC Channels 0 to 7 Address Write Only D15 MSB D00 LSBImmediate DAC Update Mode Digital-to-Analog Converter Board Programming OptionsControl Register Data Format and Definitions D09 D08 Delayed DAC Update Mode Test Mode Programming Program Example Delayed DAC Update Mode END Analog Out Pathway Analog Output Control in Immediate DAC Update ModeControl Word D15 to D0 Hex Value DAC Programming Sequence Delayed DAC Update Mode Analog Output Control in Delayed DAC Update Mode Theory of Operation Operational Overview Immediate DAC Update Mode Program Control Update Mode Digital-to-Analog Converter Board Functional Block Diagram VMEbus Interface Description A01 A02 A03 A04 VMEbus Interface Logic and Interface Signals DIG GND Maintenance