Toshiba RD-XS24SB owner manual To stop a programmed recording, Selected programme, Press Mode

Recording

Programming a recording (REC MENU) (Continued)

Deleting a timer program				Checking the remaining volume
The maximum timer program capacity is 32. Any new				1) On REC MENU Timer Programming, press
program will be rejected if the recorder is full. To enter a
				QUICK MENU.
new program, you must cancel an existing one.
				2) Press	/	to select “Disc budget calculation”
1)	Press MENU.
				then press ENTER.
2)	Press	/	to select “Timer recording”, then	The Disc budget calculation menu appears.
	press ENTER.			3) Press	/	to select a timer program, then
3)	Press	/	to select a timer program you want
				press ENTER.
	to delete.
				The recorder calculates on a bar graph how much
4)	Press QUICK MENU.
				a specific program (identified by a check mark) will
	The Quick Menu appears.
				occupy on the disc.

5)Press / to select “Program cancel”, then press ENTER.

Check the message, then delete the entry.

Note

•You cannot delete a timer program while another is executed.

To stop a programmed recording

1)Select the recording drive by pressing HDD or DVD twice.

2)Press on the front panel twice.

When you press the button once, a message appears. While the message is displayed, press the button once again.

Note

•If you press the STOP button on the remote control, a message appears. Select “Yes”, then press the ENTER button.

Pressing the ADJUST button can display or remove the check mark.

e.g.

REC

Timer Programming

1 /

1 Page

10/23(Su)17:50

MENU

Ch

Date

Start

End

Media

Pict.

Audio Result

1

10/30(Su)

7:00

-

8:30

HDD

MN 6.6

D/M2

10

11/16(We)

9:30

- 10:00

DVD

MN 6.6

D/M2

42

11/19(Sa)

10:30

- 11:30

HDD

LP 2.2

D/M1

4

11/26(Sa)

8:30

- 11:30

DVD

SP 4.6

D/M2

HDD

Elapsed

( ) Selected(current)

Available

DVD

Selected programme

Available disc space

When the entry item is marked X, the recording does not fit. Change the setting.

means this recording will not be executed due to limitation of recording time, if another is executed.

4)Correct the parameters of the timer program if necessary.

(Skip to step 6 if you do not need this.) Select an item you want to modify and press the ENTER button. The item will be ready to be altered. (When “High rate save” is set to “On”, “Pict.” cannot be changed.)

Press the ADJUST button to modify. When complete, press the ENTER button.

5)Press MODE.

Program modification is registered.

6)Press EXIT to exit the GUI.

Notes

•The nearest 48 programs are calculated at a time.

•While the recorder is preparing for or executing a programmed recording, any program modification cannot be registered. Only programs which will start after 5 minutes or later can be modified.

•Available disc volume is not displayed for a DVD-R/RW disc on which DVD-Video finalize process was executed.

32

RD-XS24SB_Ope_E_p025-036 32 8/31/05, 11:52 PM