Toshiba RD-XS24SB owner manual Turning the power off, Disc tray lock, Single sided, Double sided

DVD-RAM disc with cartridge (TYPE1/TYPE2/TYPE4)

Single sided

Turn the printed side up, and insert the cartridge into the tray frame following the direction of the arrow on the cartridge.

Double sided

Turn the desired recording/playback side up, and insert the cartridge into the tray frame following the direction of the arrow on the cartridge.

3Close the disc tray.

Press on the front panel or the OPEN/CLOSE button on the remote control.

Notes

•Use the button on the front panel or the remote control to open and close the disc tray. Do not push or hold the disc tray while it is moving. Doing so may cause the recorder to malfunction.

•Do not insert a disc which is unplayable, or any object other than a playable disc.

•Do not apply downforce to the disc tray. Doing so may cause the recorder to malfunction.

•If the disc tray stops while closing, the mechanical protection system of this recorder will open it. Do not force it to close. Doing so may cause malfunction.

•If the disc tray will not open, turn the recorder off, and press the button on the front panel or the OPEN/ CLOSE button on the remote control. This may turn the recorder on and open the disc tray. If it still won’t open, contact your nearest TOSHIBA dealer.

Turning the power off

Press ON/STANDBY on the front panel of the recorder or on the remote control.

The “Unloading” icon appears at the top right corner of the screen, and the display of the front panel shows “OFF”, then the power turns off (Standby mode.)

Caution

•If the power fails or the power cord is disconnected from a wall outlet while the recorder is in operation, the HDD or a loaded disc may become recording disabled. In such a case, executing an initialization of the disc using the formatting function of the recorder may refresh it. However, all contents stored on the disc will be completely erased by this initialization process.

•This recorder may indicate alert messages with some DVD-RAM discs right after insertion. If such a disc is used for playback or recording on other equipment, all data in the disc may be damaged and the disc will not be played. By executing an initialization of the disc using the formatting function of the recorder, the disc will become operational.

•If the recorder freezes and does not respond at all, leave it alone for about 15 minutes or longer. This may restore the recorder. After the recorder has recovered, turn it off once and turn it on again to use as usual. If the recorder is still inoperable after more than 15 minutes have passed, press and hold the ON/STANDBY button on the front panel for about 10 seconds or longer. The recorder is forced to quit and the power turns off. Turn the recorder on again and use it as usual. (This is an emergency measure, which may cause losses and/or damages of data. Avoid casual use of this measure. If you try this while the recorder is working properly, especially while the “Loading” or “Unloading” icon is flashing, it may result in initializing of the HDD.) (This 15-

minute measure is available only when “Screen protector” is set to “On.” ( page 120))

Note

•If there are any performance malfunctions of the HDD or the DVD-RAM drive, immediately discontinue use of this recorder, and disconnect the power cord from a wall outlet, then contact your dealer. Continuous use of the recorder in such a condition will aggravate the condition and result in increased cost and repair time.

Disc tray lock

You can lock the disc tray.

Press and hold on the front panel or STOP on the remote control for longer than about 3 seconds.

To unlock, during stop press the button for longer than about 3 seconds.

Note

• Turning the power off also unlocks the disc tray.

Introduction RecordingPlayback

Editing Function setup Others

21

RD-XS24SB_Ope_E_p020-024 21 8/31/05, 11:52 PM