Sony KP 43T90, KP 61V90, KP-48V90, KP-53S76, KP 53V90 Lightning, Damage Requiring Service

Page 9

Antennas

Outdoor Antenna Grounding — If an outdoor antenna is installed, follow the

Antenna Grounding According to the NEC — Refer to section 54-300 of Canadian Electrical Code for Antenna Grounding.

- When the power cord or

plug is damaged or

frayed.

precautions below.

An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits.

WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL.

Ground damps

Electric service equipment

NEC: National Electrical Code

Antenna lead-in

wire

Antenna discharge unit (NEC Section 810-20)

Grounding

conductors (NEC Section 810-20)

Ground damps

Power service grounding electrode system (NEC Art 250 Part H)

- If liquid has been spilled

into the set.

- If the set has been

exposed to rain or water.

Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Lightning

For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the receiver due to lightning and power-line surges.

Service

Damage Requiring Service

Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions:

- If the set has been

subject to excessive shock

by being dropped, or the

cabinet has been

damaged.

5

Image 9
Contents Projection TV Precaucion Code SET Remote ControlTable of Contents Welcome Using This ManualPrecautions SafetyInstalling Use Important SafeguardsInstallation Service Damage Requiring ServiceLightning For Safety Carrying Your Projection TV Installing the Projection TV Installing and Connecting the Projection TVRecommended viewing area VerticalMaking Connections Connector TypesCable box and cable Connecting a cable boxCable or antenna Cable and antennaConnecting a cable TV system Connecting a VCR and projection TV to a cable boxAntenna to a VCR Video Connecting a satellite receiver SAT Connecting a satellite receiver Connecting a camcorder Connecting a DTV digital television receiverConnecting a DVD Player Upper illustration Connecting an audio system Control S OUT on the projection TV Connecting a Sony Sava series speaker systemUsing the Remote Control Basic Set UpSetting Up the Projection TV Automatically Inserting the batteriesTo perform Auto SET UP again Adjusting the Convergence Automatically Flash FocusPress Volume to continue Press Channel + to preset channels automaticallyUsing Your New Projection TV Watching the TVSpeed Surf Jump TV, Video 1, Video 2, Video 3 and VideoCaption Vision XDS Extended Data ServiceNo display BBE, Surround, Simulated and Effect Off. see Effect onWatching Two Programs at One Time PIP Using the Yellow Labeled Buttons for PIP OperationsPIP is snowy, the entire screen may If one of the pictures received throughBecome unstable. In this case, erase Snowy channel. see Channel SkipLearning Menu Selection Adjusting Your SET UP menusTo exit from the menus at any time Press V or v to highlight the desired optionUsing the Video Menu To restore the factory settingsTo select the Video menu To select the Audio menu Using the Audio MenuSpeaker Audio OutSava SP Control To select the Timer menu Using the Timer MenuTimer Daylight SavingsCh Using the Channel Set Up Menu To select the Channel Set Up ch menuFavorite Channel will not function with AUX input Skip/Add Auto ProgramCable Setting and Selecting Setting Favorite Channel manuallyFavorite Channel Using Favorite Channel Press Menu when you are doneChanging Favorite Channel choices To select the Set Up menu Using the Set Up MenuParental ControlFlash Focus Video LabelActivating the Parental Control Feature Using the Parental Control FeatureTo deactivate the Parental Control FeatureTo unlock the Parental Control feature temporarily Selecting a Custom RatingPress V or v to select Custom, First, select a TV rating Press V or v to select Movie Rating Second, select a movie ratingCanada Changing the Password If you have forgotten your password Enter a new four digit password using the 0-9 buttonsWhat the Ratings Mean Ratings in U.S.ATV ratings Movie ratingsTV-NR rating is shown as Unrated in the menu Ratings in CanadaAbout the extenders of U.S. TV ratings Canadian English Language ratingsCanadian French Language ratings If the remote control doesn’t work Setting the Manufacturers CodeOperating Video Equipment VCR manufacturer code numbersDVD Player manufacturer code MDP manufacturer code numbersNumbers To operate video equipmentManufacturer code numbers cable box Operating a Cable Box or Satellite Receiver SATTo operate the cable box or satellite receiver SAT Press TV FUNCTION. Then useSound TroubleshootingCannot receive any channels Specifications Fixed/Variable IndexVCR