Safety
Cl Operate the projection TV only on 120 V AC.
Cl The plug is designed, for safety purposes, to lit into the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer.
Cl If any liquid or solid object should fall inside the cabinet, unplug the projection TV immediately and have it checked by qualified service personnel before operating it further.
0If ygu will not be using the projection TV for several days, disconnect the power by pulling the plug itself. Never pull on the cord.
For details concerning safety precautions, see “Important Safeguards” on page 4.
Installing
To prevent internal heat buildup, do not block the ventilation openings.
Do not install the projection TV in a hot or humid place, or in a place subject to excessive dust or mechanical vibration.
Avoid operating the projection TV at temperature below 5°C (4 1“F).
If the projection TV is transported directly from a cold to a warm location, or if the room temperature changes suddenly, the picture may be blurred or show poor color. In this case,please wait a few hours to let the moisture evaporate before turning on the projection TV.
To obtain the best picture, do not expose the screen to direct illumination or direct sunlight. It is recommended to use spot lighting directed down from the ceiling or to cover the windows that face the screen with opaque drapery. It is desirable to install the projection TV in a room where the floor and walls are not of a reflective material.
Note on convergence adjustment
Before you use your projection TV, make sure to adjust convergence. For details, see“Adjusting the Convergence Automatically - FLASH FOCUSrM
TruStmound is a trademark of SRS Labs, Inc. SRS and the SRS symbol are registered trademarks
of SRS Labs, Inc. in
BBE and BBE Symbol are trademarks of BBE Sound, Inc. and are licensed by BBE Sound, Inc. under U.S. Patent No. 4,638,258 and 4,482,866.
ATTENTION
Pour prevenir les chocs Clectriques, ne pas utiliser cette fiche polarisee avec un prolongateur, une prise de courant ou une autre sortie de courant, sauf si les lames peuvent tre inserees a fond sansen laisser aucune partie a decouvert.
Owner’s Record
The mode1and serial numbers are located at the rear of the projection TV, below the Sony logo, on the sticker, and also on the TV box (white label). Record these numbers in the spacesprovided below. Refer to them whenever you call upon your Sony dealer regarding this product.
Mode1 No.
Serial No.
guidelines for energy efficiency.
ENERGY STAR@is a U.S. registered mark.
3