System Setup Options

Setup, cont.

Pressing OK at the SYSTEM SETUP screen accesses the System Setup Options for Volume Punch-Through control Setup, Time Setup, Date Setup, Backlight Setup and System Reset.

Volume/Mute Control and Punch-Through Feature

Your remote allows you to select which device mode controls VOLUME and MUTE. This remote is initially set for all device modes to use their own Volume/Mute control if present. If the programmed code does not have Volume/Mute operation, then VOLUME and MUTE will “punch- through” (hand-over) control to the TV mode device without you needing to change to TV mode. Note: Any mode chosen for Volume/ Mute control must have its own Volume/Mute function or else VOLUME and MUTE will not function.

Setting ALL Volume/Mute Control to any one Mode (ALL VOL. SET) This routine can set all Modes to “punch-through” to any one chosen Mode for Volume/Mute button control without needing to change to that Mode.

1.Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button.

2.Press the down navigation button until SYSTEM SETUP is displayed.

3.Press and release OK. VOL/MUTE SETUP is displayed.

4.Press and release OK. ALL VOL. SET is displayed.

5.Press and release OK. ALL VOL. MODE? is displayed.

6.Press and release desired Mode key (TV, VCR, DVD, etc.) for Volume/ Mute control. PLEASE WAIT is briefly displayed, followed by SUCCESS and the remote returns to normal operation.

All Modes will now punch-through to your chosen Mode for Volume/ Mute control. If the chosen Mode has no Volume/Mute commands of its own, “Volume Error” is shown in the display and the remote returns to normal operation.

Setting any Mode to use its own Volume/Mute Control (MODE VOL. SET)

This sets any Mode to use only its own Volume/Mute control, i.e. Volume/Mute punch-through is disabled for this Mode. Note - If your chosen Mode has no Volume/Mute functions of its own then the Volume/Mute buttons will do nothing.

1.Press and hold the SETUP button until CODE SETUP is displayed (takes about 3 seconds), then release the SETUP button.

2.Press the down navigation button until SYSTEM SETUP is displayed.

3.Press and release OK. VOL/MUTE SETUP is displayed.

4.Press and release OK. ALL VOL. SET is displayed.

5.Press the down navigation button until MODE VOL. SET is displayed

6.Press and release OK. MODE VOL. MODE? is displayed.

7.Press and release desired Mode key (TV, VCR, DVD, etc.) to be disabled for Volume/Mute punch-through control. PLEASE WAIT is briefly displayed, followed by SUCCESS and the remote returns to normal operation.

The chosen Mode will now use its own Volume/Mute control.