GE 24999 Code Entry using On-screen Code List, Device can be selected, Direct Code Entry

Page 8

Code Entry

Code Setup Options: Pressing OK at the CODE SETUP screen presents 3 options for programming a Mode with codes. These are LIST CODES (lets you enter a 4 digit code from the on-screen code list), ENTER CODES, (lets you enter a 4 digit code directly from the printed code list) SEARCH CODES, (lets you search through the codes stored in the remote to find the correct one for your device).

Code Entry using On-screen Code List

1.Manually turn on the device to be controlled.

2.Press and hold the SETUP button until CODE SETUP is displayed

(takes about 3 seconds), then release the SETUP button.

3.Press and release OK. LIST CODES is displayed.

4.Press and release OK. MODE KEY? is displayed.

5.Press and release the desired mode button (TV, VCR, DVD, etc.). The Mode is displayed along with its currently programmed code.

6.Using the UP/DOWN buttons, select the Device type to be programmed (TV, VCR, DVD, etc. Note - For TV Mode, only a TV

Device can be selected.

7.Press and release OK to confirm selection.

8.The Code List Brand and Code will now be displayed (e.g. Admiral 0000). Use the UP/DOWN buttons to select the Brand and LEFT/ RIGHT buttons to select the Code. Codes can be tested on your device using VOLUME, MUTE, CHANNEL, POWER, INPUT, PLAY, STOP, FF, REWIND and PAUSE. Once the correct code has been found, press and release OK to install the Code.

9.PLEASE WAIT is briefly displayed, followed by SUCCESS and the remote returns to normal operation.

10.With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand of device.

Direct Code Entry

1.Manually turn on the device to be controlled.

2.Press and hold the SETUP button until CODE SETUP is displayed

(takes about 3 seconds), then release the SETUP button.

3.Press and release OK. LIST CODES is displayed.

4.Press the DOWN navigation button until ENTER CODES is displayed.

5.Press and release OK. MODE KEY? is displayed.

6.Press and release the desired mode button (TV, VCR, DVD, etc.). The Mode is displayed along with its currently programmed code.

7.Enter the 4 digit code from the code tables (on separate sheet). After the 4th digit is entered SUCCESS is displayed and the remote returns to normal operation.

If an invalid code is entered, CODE ERROR is shown in the display and the remote returns to normal operation.

8.With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your equipment, try one of the other codes for your brand of device.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 24999 Table of Contents Introduction Button Functions DVD/DVR Punch-Through Feature Button Functions,Setup Setup, Code Entry using On-screen Code List Code EntryDevice can be selected Press and release OK to confirm selectionPress the Channel UP button or POWER, or Play for VCRs Code Identification FeatureCode Entry, Searching for CodesSystem Setup Options Volume/Mute Control and Punch-Through FeatureSetup, Setup, Setup, Timer Setup Setting and Clearing a TV Sleep Timer TV Sleep SetupTo set a TV Sleep Timer no Zzz in normal display To clear a TV Sleep Timer Zzz in normal displayTo clear a Timer Timer Bell in normal display Remote Code LearningTips On Learning Learning Notes Tips On Learning,Tips On Learning, Learning Commands Clearing Commands To Clear all Learned Commands under a modeTroubleshooting Day Limited WarrantyRemote does not operate some features of your product Remote does not operate your productUniversal Remote
Top Page Image Contents