Remote Control
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment. If you have video equipment other than Sony brand that you want to control with the TV’s remote control, use the following procedure to program the remote control.
✍The equipment must have infrared (IR) remote capability in order to be used with the remote control.
1Turn to the list of “Manufacturer’s Codes” on page 51, and find the
2While holding down DVD/VCR FUNCTION or SAT/CABLE FUNCTION, press
RESET. Then release both buttons. (The DVD/VCR FUNCTION and SAT/CABLE FUNCTION buttons will flash.)
3Press either DVD/VCR FUNCTION or SAT/CABLE FUNCTION, depending on which button you want to program.
4Enter the three-digit manufacturer’s code number.
5Press ENT.
✍You must do step 5 within 10 seconds of step 4, or you must redo steps 3 through 5.
6To check if the code number works, aim the TV’s remote control at the equipment and press the POWER button that corresponds with that equipment. If it responds, you are done. If not, try using another code listed for that manufacturer.
Notes
❑If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.
❑If you enter a new code number, the code number you previously entered at that setting is erased.
❑In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment’s own remote control.
❑Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reset.
50