Onkyo DV-BD606 Precautions, For U.S. Models, For Canadian Models, Modèle pour les Canadien

Page 4

PRECAUTIONS

Do not use this unit when there’s the possibility of moisture condensation occurring. Doing so may damage your discs and certain parts inside

this unit.

If condensation does occur, remove all discs and leave this unit turned on for two to three hours. By this time, the unit will have warmed up and any condensation will have evaporated.

12.Region Codes—The BD/DVD standard uses region codes to control how discs can be played around the world, the world being divided into three regions (BD) or six regions (DVD). This unit will only play BD/DVD discs that match its region code, which can be found on its rear panel (, ).

13.About this Manual—This manual explains how

to use all of this unit’s functions. Although the BD/DVD standard offers many special features, not all discs use them all, so depending on the disc being played, this unit may not respond to certain functions. See the disc’s sleeve notes for supported features.

This unit contains a semiconductor laser system and is classified as a “CLASS 1 LASER PRODUCT”. So, to use this model properly, read this Instruction Manual carefully. In case of any trouble, please contact the store where you purchased the unit.

To prevent being exposed to the laser beam, do not try to open the enclosure.

DANGER:

VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. DO NOT STARE INTO BEAM.

CAUTION:

THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

The label on the right is applied on the rear panel.

1.This unit is a CLASS 1 LASER PRODUCT and employs a laser inside the cabinet.

2.To prevent the laser from being exposed, do not remove the cover. Refer servicing to qualified personnel.

For U.S. Models

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

4

EN

Image 4
Contents DV-BD606 Important Safeguards Precautions PowerInstalling this Unit Preventing Hearing Loss CautionPrecautions For U.S. ModelsFor Canadian Models Modèle pour les CanadienSupplied Accessories Trademark Information Maintenance ServicingIR signal check CopyrightContents Features FeaturesSymbols Used in this Manual Symbol DescriptionFront Panel Functional OverviewRear Panel Remote Control Functional OverviewInstalling the Batteries in the Remote Control Using a Remote ControlOpen the cover Insert batteries Close the coverFront Panel Display Example of Display MessageMode Loading a discConnections Connection to the TVHdmi Output Mode and Actual Output Signals Press ResolutionPress Resolution Copyright protection system ConnectionsAudio signals output from Hdmi OUT jack Hdmi Audio SettingDisc type Audio recording format Hdmi Audio Out setting DTS-CDConnection to an Audio System Channel Analog Audio ConnectionDigital Audio Connection Audio Output Analog L/RConnecting the AC Cord Disc type Audio recording format Digital Out settingBitstream LpcmPlayable Discs and Files Information on PlaybackUnplayable Discs and Files Structure of Disc / SD Memory Card Contents Information on PlaybackColor Systems Region CodesChapter information Title informationBit rate information Track / File informationBasic Playback PlaybackOperations Using Title Menu Disc Menu, and Pop-up Menu Basic PlaybackPause Resume PlaybackInsert an audio CD or a disc with MP3 files Playing Back an audio CD and a Disc with MP3 FilesUse s / B to go back and forward between the hierarchies Press Setup to exit Use K / L to select , then press Enter Use K / L to select Media Select settingReading the SD Memory Card Press Enter repeatedly to select SD MemoryRemoving the SD Memory Card Label facing upFile list will appear Special Playback Fast Forward / Fast ReverseSlow Forward Playback Step by Step PlaybackSpecial Playback RepeatRandom Playback Camera AngleUsing Search Search modeSearch Marker searchSwitching Subtitles Special SettingsSwitching Audio Soundtrack Special Settings Setting the BD Audio ModeFunction Setup Using the Setup MenuPress Setup to exit Follow the procedure below depending on the setting itemsFunction Setup Stop mode, press Setup Use K / L to select , then pressUse K / L to select your desired Setting items Follow the procedure below Depending on the setting itemsSetting items Options LanguageSubtitle Disc MenuHdmi Video Resolution Progressive ModeVideo TV AspectStill Mode Audio DRCSpeaker setting Digital out settingQuick Hdmi Audio Out Audio Mute Digital Out For Default Press Enter to reset to the default Menu Setting items Options DescriptionsSpeaker Size Channel LevelDelay Time Listening position Delay time Center 0ft to 60ft 12ftPosition to the speaker to get the ideal Surround 0ft to 60ft 10ftParental Proceed to a COthers Hdmi CECThen press Enter Use K / L to select a desired optionInitialize Memory DeviceProblem TroubleshootingSolution Glossary Language Code Language CodeGeneral SpecificationsTerminals Memo Onkyo U.S.A. Corporation Onkyo Europe Electronics GmbHOnkyo Europe UK Office Onkyo China Limited
Related manuals
Manual 96 pages 23.87 Kb