Onkyo DV-BD606 Open the cover Insert batteries, Close the cover, Using a Remote Control

Page 10

FUNCTIONAL OVERVIEW

Installing the Batteries in the Remote Control

Install the batteries (AAx2) matching the polarity indicated inside battery compartment of the remote control.

1Open the cover.

2Insert batteries.

Make sure to match + and - on the batteries to the marks indicated in the battery compartment.

3Close the cover.

Note

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

Do not mix new and old batteries together.

Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

Make sure that the + and - ends of each battery match the indications in the battery compartment.

Remove batteries from battery compartment that is not going to be used for a month or more.

When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a Remote Control

Keep in mind the following when using the remote control:

Make sure that there are no obstacles between the remote control and the infrared sensor window on the unit.

Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the infrared sensor window of the unit.

Remote control for different devices can interfere with each other. Avoid using remote control for other device located close to the unit.

Replace the batteries when you notice a fall off in the operating range of the remote control.

The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

BLU-RAY DISC PLAYER DV-

 

30˚

30˚

 

16 feet

23 feet

16 feet

(5m)

 

(7m)

(5m)

10

EN

Image 10
Contents DV-BD606 Important Safeguards Installing this Unit PrecautionsPower Preventing Hearing Loss CautionFor Canadian Models PrecautionsFor U.S. Models Modèle pour les CanadienIR signal check Supplied AccessoriesTrademark Information Maintenance Servicing CopyrightContents Symbols Used in this Manual FeaturesFeatures Symbol DescriptionFront Panel Functional OverviewRear Panel Remote Control Functional OverviewOpen the cover Insert batteries Installing the Batteries in the Remote ControlUsing a Remote Control Close the coverMode Front Panel DisplayExample of Display Message Loading a discConnections Connection to the TVPress Resolution Copyright protection system Hdmi Output Mode and Actual Output SignalsPress Resolution ConnectionsDisc type Audio recording format Hdmi Audio Out setting Audio signals output from Hdmi OUT jackHdmi Audio Setting DTS-CDDigital Audio Connection Connection to an Audio SystemChannel Analog Audio Connection Audio Output Analog L/RBitstream Connecting the AC CordDisc type Audio recording format Digital Out setting LpcmPlayable Discs and Files Information on PlaybackUnplayable Discs and Files Color Systems Structure of Disc / SD Memory Card ContentsInformation on Playback Region CodesBit rate information Chapter informationTitle information Track / File informationBasic Playback PlaybackPause Operations Using Title Menu Disc Menu, and Pop-up MenuBasic Playback Resume PlaybackInsert an audio CD or a disc with MP3 files Playing Back an audio CD and a Disc with MP3 FilesUse s / B to go back and forward between the hierarchies Reading the SD Memory Card Press Setup to exit Use K / L to select , then press EnterUse K / L to select Media Select setting Press Enter repeatedly to select SD MemoryRemoving the SD Memory Card Label facing upFile list will appear Slow Forward Playback Special PlaybackFast Forward / Fast Reverse Step by Step PlaybackSpecial Playback RepeatRandom Playback Camera AngleSearch Using SearchSearch mode Marker searchSwitching Subtitles Special SettingsSwitching Audio Soundtrack Special Settings Setting the BD Audio ModePress Setup to exit Function SetupUsing the Setup Menu Follow the procedure below depending on the setting itemsUse K / L to select your desired Setting items Function SetupStop mode, press Setup Use K / L to select , then press Follow the procedure below Depending on the setting itemsSubtitle Setting items OptionsLanguage Disc MenuVideo Hdmi Video ResolutionProgressive Mode TV AspectStill Mode Audio DRCSpeaker setting Digital out settingQuick Hdmi Audio Out Audio Mute Digital Out Speaker Size For Default Press Enter to reset to the defaultMenu Setting items Options Descriptions Channel LevelPosition to the speaker to get the ideal Delay TimeListening position Delay time Center 0ft to 60ft 12ft Surround 0ft to 60ft 10ftParental Proceed to a COthers Hdmi CECInitialize Then press EnterUse K / L to select a desired option Memory DeviceProblem TroubleshootingSolution Glossary Language Code Language CodeGeneral SpecificationsTerminals Memo Onkyo Europe UK Office Onkyo U.S.A. CorporationOnkyo Europe Electronics GmbH Onkyo China Limited
Related manuals
Manual 96 pages 23.87 Kb