Samsung BD-P1200 manual Unpacking, Setting the Remote Control, Preparing the Remote Control

Unpacking

Instruction Manual

(AK68-01357A)

Remote Control

(AK59-00070A)

Quick Guide

(AK68-01358A)

Setting the Remote Control

You can control certain functions of your TV with this remote control.

Control function buttons include : TV POWER,

CH , VOL + -,TV MUTE, TV INPUT SEL. button.

To determine whether your television is compatible, follow the instructions below.

1.Switch your television on.

2.Point the remote control towards the television.

3.Press and hold the TV POWER button and enter the two-figure code corresponding to the brand of your television, by pressing the appropriate number buttons. (see the next page for the code list).

Result: If your television is compatible with the remote control, it will switch off.

It is now programmed to operate with the remote control.

■ If several codes are indicated for your television brand, try each one in turn until

■If you replace the remote control's batteries, you must set the brand code again.

Preparing the Remote Control

Install Batteries in the Remote Control

•Open the battery cover on the back of the remote control.

•Insert two AAA batteries. Make sure that the polarities (+ and -) are aligned correctly.

•Close the battery cover.

If the remote does not operate properly:

•Check the polarity + - of the batteries (Dry-Cell)

•Check if the batteries are drained.

•Check if remote sensor is blocked by obstacles.

•Check if there is any fluorescent lighting nearby.

Dispose of batteries according to local environmental regulations. Do not put them in the household trash.

You can then control the television using the following buttons after pressing the TV button.

■ The functions listed above will not necessarily

NOTE

work on all televisions. If you encounter problems, operate the television directly.