Function setup
Customizing the Function Settings
You can change the default settings to customize performance to your preference.
General Operations
1.Press 
/ 
to select Settings in home menu while in full stop mode, the Settings menu appears.
2.Press 
button, then use 
/ 
button to select the setting options.
3.Press OK button.
4.Press 
or RETURN button to return to the previous menu.
IP Settings |
|
Link Status | Link Down |
MAC Address | 00:23:18:75:b1:2b |
|
|
IP Mode | Dynamic |
IP Address | 0.0.0.0 |
Subnet Mask | 0.0.0.0 |
Gateway | 0.0.0.0 |
Primary DNS | 0.0.0.0 |
Secondary DNS | 0.0.0.0 |
Home Menu
BD-ROM
Settings
Connected
Network
Info
Quick Setup
Display
Audio
Speaker
Display
HDMI Status | Connected |
HDMI Preferred Format 
1080p(HDMI)
Resolution | HDMI Auto |
TV Aspect | 16:9 Pillarbox |
Film Mode | Off |
Deep Color | On |
Apply |
| Cancel |
2.Press 
/ 
to select IP Mode, then press OK.
3.Press 
/ 
to select an IP mode. You can select:
•Off — Disables the network interface.
•Manual — Lets you manually configure network settings, such as IP address, subnet mask, and gateway settings.
•Dynamic — Uses DHCP to automatically obtain an IP address.
4.Press 
or RETURN to go to the previous menu.
A
Language
Settings menu items submenu display area
Network Connection Setting
1.Press 
/ 
to select Network in stop mode, the network connection menu appears.
Wired
Wireless
Network Test
2.Press 
button, then use 
/ 
button to select the desired connection setting.
3.Press OK button.
Configuring a wired Internet connection
1.Press 
/ 
to select Wired, then press OK to confirm. The IP Settings screen appears.
If the network connection is active, Link Up appears next to Link Status. If the network connection is not active, Link Down displays next to Link Status.
Configuring a wireless Internet connection
This section describes how to configure the BD player for accessing the internet via a WiFi connection.The procedure for connecting to a wireless network depends on various network parameters. Read the following configuration methods to determine which instructions to use to connect to your network.
I.Connection to the wireless Network which you select
a.Connecting to an Unencrypted Wireless Network
b.Connecting to an Encrypted Wireless Network
II.Connection to the wireless Network using
a.Connecting to a Wireless Network Using WPS Pushbutton
b.Connecting to a Wireless Network Using WPS PIN
III.Connection to the wireless Network using Manual IP Configration
Description of the Wireless Network List Display
Choosing “Network List” in the wireless network setup menu will cause a list of available WiFi networks to appear, as shown below:
|
| Network List | |
|
|
|
|
| WiFi a |
| |
| WiFi b g n | Panda | |
| WiFi a | dlink_media | |
| WiFi b g | NTGR 11g | |
| WiFi b g | Airport_SN | |
|
|
|
|
28