Toshiba BDX2700KU owner manual Category Icon Definition, WiFi-me

Customizing the Function Settings

The symbols that might appear next to each listed wireless network in the network list are as follows:

Category	Icon	Definition
Connected		When the BD player is
		turned on, it will connect
		to the wireless network
		displaying this symbol.
		Typically, this is the last
		wireless network connected
		before powering down.
Saved		The wireless network prop-
		erties have been saved in
		the BD player’s memory.
Wireless Security		The wireless network data
		is not encrypted.
		The wireless network data
		is encrypted; a ‘security key’
		must be entered so that the
		BD player can share data
		over the network.
		The wireless network data
		is encrypted; the encryption
		scheme is not supported by
		the BD player.
Wireless Protocol	a	The wireless network sup-
		ports 802.11a

bThe wireless network sup- ports 802.11b

gThe wireless network sup- ports 802.11g

nThe wireless network sup- ports 802.11n

Signal Strength Strong Signal

Good Signal

Medium Signal

Weak Signal

No Signal

I.Connection to the wireless Network which you select

1.Press / to select Wireless, then press OK to confirm. the following screen will appear.

Network List

WiFi Protected Setup (WPS)

Manual

IP Settings

2.Press / to select Network List, then press OK. A list of existing wireless networks near the BD player will appear (It may take several seconds for this list to be created). For example:

	Network List
WiFi a	WiFi-me*
WiFi b g n	Panda
WiFi a	dlink_media
WiFi b g	NTGR 11g
WiFi b g	Airport_SN

3.Press / to select the desired wireless network, and press OK to confirm.

a. If the BD player is connected to an Unencrypted Wireless Network, a menu similar to the following will

appear:

WiFi-me

Connect WPS Pin Delete Cancel

4.Press / to highlight Connect, and press OK. If the

wireless network is functioning, icon and a message “Connection to XXX...Success” will appear on the TV.

5.Press OK to close the message. The BD disc player is now connected to the network. From now on, when you turn on the player, it will automatically connect to the network; there is no need to repeat these steps again.

Note: If you do not see this message, the BD player was not able to connect to the network.

b. If the BD player is connected to an Encrypted Wireless Network, a menu similar to the following will appear:

WiFi-me

Password

Connect WPS Pin Cancel

Press ENTER to open keyboard

4.Press ENTER to activate the on-screen keyboard. Carefully enter the network password by using the / / / to highlight the desired letter on the keyboard, and then pressing OK. (If you make a mistake, use the

backspace key to erase the mistake.)

FUNCTION SETUP

29