English
Connect USB device
A USB flash drive provides an additional
memory to software upgrade and enjoy
You can also enjoy playing back MP3/
JPEG/MPEG4 files stored in the USB flash
drive.
1.Connect the USB flash drive to the USB jack on this product.
Notes:
- To enjoy
- For some
- TOSHIBA does not guarantee 100% compatibility with all USB flash drives.
Connect Power
1.Connect the AC power cable to:
-the wall socket.
•The product is ready to be set up for use.
Notes:
–Before connecting the AC power cord, ensure you have completed all other connections.
–Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back of the unit.
–The type plate is located on the back of the unit.
4 Preparation
Always follow the instructions in this chapter in sequence.
Note:
-Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.
Prepare the remote control
1.Open the battery compartment.
2.Insert one R03 battery with correct polarity
3.Close the battery compartment.
Notes:
-If you are not going to use the remote control for a long time, remove the battery.
-Risk of explosion! Keep battery away from heat, sunshine or fire. Never discard battery in fire.
•The maximum operable ranges from the unit are as follows.
-Line of sight: approx. 10 m
-Either side of the centre: approx. 7 m within 30°
-Above: approx. 7 m within 30°
-Below: approx. 7 m within 30°
7 m | 10 m | 7 m |
7 m | 10 m | 7 m |
10