Magnavox MBP5210 Installing the Batteries in the Remote Control, Using the Remote Control, Above

■Installing the Batteries in the Remote Control

Install 2 AAA (1.5V) batteries matching the polarity indicated inside battery compartment of the remote control.

CCaution

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

•Make sure that the + and - ends of each battery match the indications in the battery compartment.

•Remove batteries from the battery compartment when the remote is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

■Using the Remote Control

Remote Control Usage Guidelines:

•Make sure that there are no obstacles between the remote control and the infrared sensor window on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the infrared sensor window of the unit.

•Remote controls of different devices can interfere with each other. Avoid using a remote control of another device which is located close to the unit.

•Replace the batteries when you notice a fall-off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

Line of sight	: approx. 23 feet (7 m)
Either side of the center	: approx. 16 feet (5 m) within 30°
Above	: approx. 16 feet (5 m) within 15°
Below	: approx. 10 feet (3 m) within 30°
	30˚	30˚

EN-12