FUNAI MBP5130/F7 Network Connection, Connection Test, Press OK, then press Setup to exit

Network Connection

[SETUP]”Others"“Network Connection”

Set up network connection settings in order to use BD-Live, Netflix / Blockbuster / VUDU or network update function.

Connection Test

After you enable a network connection or change the network settings, always perform the connection test to check if the connection is correctly made.

1.In “Network Connection” menu, use [K/L] to select “Connection Test”, then press [OK]. Connection test will start automatically and the test result will appear right after the connection test finishes.

•“Testing...” : The test is in progress.

•“Pass” : Connection test is successfully completed.

•“Fail” : Connection test failed. Check the connection settings.

If the connection test passes, press [OK].

•Confirmation screen of the network selection will appear.

e.g.) Wired connection

Others

Connection Test

Network Selection Wired

then press ‘OK’ .

Press [OK] again to display the confirmation screen of network settings.

Others

Connection Test

IP Address	xxx.xxx.xxx.xxx
Subnet Mask	xxx.xxx.xxx.xxx
Default Gateway	xxx.xxx.xxx.xxx
Primary DNS	xxx.xxx.xxx.xxx
Secondary DNS	xxx.xxx.xxx.xxx
then press ‘OK’ .

2. Press [OK], then press [SETUP] to exit.

Note

•If the connection test passes, you are ready to use BD-Live, Netflix / Blockbuster / VUDU or network update function using the Internet without making any additional settings.

•If the connection test fails, you may need to change the MAC address settings on your router. You can check the MAC address of this unit on “Custom” screen. (Refer to “Custom (Wired)“ on page 39.)

•When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connected to any other network device(e.g. a router, PC, etc.), you may have to power cycle the modem to reset the settings on the modem.

•“Connection Test” is not available when “Disable” is selected in “Network Connection”.

Network Selection

Wired

Select “Wired” if you made a wired connection and set the setting to “Easy”(wired) or “Custom”(wired), in accordance with your network environment.

<Easy (Wired)>

Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the

default settings.)
- IP Address Setting	Auto(DHCP)
- DNS Setting	Auto(DHCP)
- Proxy Setting	Do Not Use
- Connection Speed	Auto
- BD-Live Setting	Allow

If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below.

1.In “Network Connection” menu, use [K/L] to select “Network Selection”, then press [OK].

2.Use [K/L] to select “Wired”, then press [OK].

3.Use [K/L] to select “Easy”, then press [OK].

•The unit will start the connection test automatically and the test result will appear right after the test finishes.

4.Press [OK] to activate the network settings and set the network connection automatically. Press [SETUP] to exit.

Note

•The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure.

<Custom (Wired)>

In following cases, select “Custom”(wired) to set each setting as necessary.

-When connection test failed with the setting of “Easy”(wired).

-When instructed by your Internet service provider to make specific settings in accordance with your network environment.

39