Additional Information:
When viewing a programme, pressing the info key will display the information banner.
SAMSUNG
Note:
If the receiver was previously working on a channel and the“No Signal” icon appears, you may have one of the following problems:
Signal degraded heavily by poor weather Channel no longer broadcasting and no carrier was detected.
Dish not aligned to the correct satellite LNB power switched off in the menu Faulty cable or LNB.
The Signal and Data level meter:
Press the Signal key during view mode to display the signal and data level for the current channel. Use this feature to assist dish alignment or fault finding should there be a reception problem.
Diagnostic Information:
For more information on the receiving signal, press the INFO key to display the diagnostic Screen:
The diagnostic screen displays detailed broadcast information in real time. Press INFO key again to return to the signal meters or ESC to return to Picture.
Signal
Data
Use INFO key for diagnostic info.
|
|
| Signal | |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Data | |
|
| Video | ||
| Pic. Size: | 544x576 | ||
| Frames/Sec: | 25.00 |
|
|
| Asp. Ratio: | 4:3 |
|
|
| Bits/Sec: | 15000000 |
| |
|
| Audio | ||
| Channel: | Stereo | ||
| Emphasis: | Off | ||
| Sample Rate: | 48.00kHz | ||
|
|
|
|
|
Memory Status:
At any time you can check the memory status on you receiver.
The indicator shows the amount of receiver memory used by the stored channels.
Press:
Menu, Channel Setup, Memory Status :
All channels are stored in memory
Memory Used
13