TV Type, UHF Channel, Enable TV Scart RGB

TV/VCR settings:

The TV/VCR menu contains various options that allow you to configure the receiver to suit your system:

Press Menu, select Installation to access the TV/VCR Menu:

TV Type

Standard (4:3)

UHF Channel

Enable TV SCART RGB

Enable TV SCART S-Video

Enable VCR SCART S-Video

38 OFF OFF OFF

The following options are available:

TV Type:

Select between a standard aspect ratio TV (4:3) or Wide-screen (16:9) TV. 16:9 mode is only active when a programme is transmitted in 16:9 format.

With a modern 16:9 TV, the switch to 16:9 mode is automatic if connected via a full SCART.

With a modern 4:3 TV, 16:9 mode will produce a “Letter Box” format if connected via a full SCART.

UHF Channel:

Use this option to change the TV UHF modulator output channel. The default channel is CH38. If this is already occupied by a local TV channel, VCR or you are experiencing picture interference, use this option to re-tune your satellite receiver to a different UHF channel. Remember to re-tune your TV and VCR to the new channel.

Enable TV SCART RGB:

When OFF, the TV SCART outputs composite video signal. If you have a RGB compatible TV, switch this option to ON to enjoy better picture quality.

Enable TV SCART S-Video:

Select this option only if your TV is S-Video compatible.

Note: 1. If your TV is not compatible, a Black and White picture will result.

2.This option is NOT available if TV SCART is set to RGB. Enable VCR SCART S-Video:

Select this option only if your VCR is S-Video compatible.

Note: 1. If your VCR is not compatible, a Black and White picture will result. 2. This option is NOT available if TV SCART is set to RGB.