Atek electronic Multimedia Remote Control user manual Special Applications

Page 10

Special Applications

Using One Tote-Remote to Control Multiple Computers

One Tote-Remote can be used to control multiple computers. Each computer must have its own receiver. You will need to follow the instructions on page 5 of this User’s Manual for using the reset button on each receiver to learn the ID code of the remote control. The receivers will then all use this same ID code to receive signals from the remote control. To change the ID code again, simply follow the same procedure again.

Using Multiple Tote-Remotes with One Computer

Since a receiver can only operate on one ID code at a time, all the remote controls would have to be set to the same ID code in order to control one receiver. Although you can randomly reset your Tote-Remote’s ID code (see Trouble- Shooting section), there is no way to set the Tote-Remote ID code to a specific ID code. Therefore, the only way you could use two (or more) remote controls with one receiver is if by unlikely chance you bought two remote controls that were set in the factory to the same ID code or if you randomly reset one remote control to the same ID code as another remote control. Both scenarios are highly unlikely.

9

Image 10
Contents User’s Manual For Tote-Remote Table of Contents Important Safety & Health Information Page Introduction Installation Features & Operation Page Operation Overview Special Applications Compatibility & System Requirements Troubleshooting Engage the safety lock feature described on MAINTENANCE, SERVICE, & Support Also please note the following important informationONE Year Limited Warranty Save Your Receipt AS Proof of Purchase Date Canada Statement Regulatory InformationFCC Statement LaserModel # RM100 Serial # Purchase RecordDate of Purchase For service and support, please contact Atek, Inc Contact InformationTote-Remote User’s Manual Rev