still be in Valet Mode. This applies to all states of the system including arm, disarm, and Valet Mode.
Power saver mode
Your system will automatically enter Power Saver Mode while armed or in Valet Mode, after a period of time in which no oper- ation has been performed. This lowers the current draw on the vehicle's battery. Power Saver Mode takes over under the following conditions:
➤Power Saver when the system is armed: After the system has been armed for 24 hours the LED will flash at half its normal rate, decreasing the system's current draw.
➤Power Saver in Valet Mode: When the system enters Valet Mode the LED illuminates steadily. If the vehicle is not used (ignition is not turned on) for a one hour period while the system is in Valet Mode, the LED will shut off. If the system remains in Valet Mode, the LED will come back on the next time the ignition is turned on and then back off.
Programming options
Programming options control your system's normal, operational
30 | © 2008 Directed Electronics — All rights reser ved |