Programming a Macro
You can program your
Example: To set up the Macro mentioned above on the key labeled A on your
1.Press and hold SETUP until red light (LED under device key) blinks twice (the red light will blink once then twice).
2.Press 9 9 5.
3.Then press the A key to which the Macro will be assigned.
4.Next press TV, POWER, VCR, POWER, SAT, POWER.
5.To store the Macro, press and hold SETUP until red light (LED under device key) blinks twice (the red light will blink once then twice).
Result: whenever you press the A key, the
-Each MACRO can consist of a maximum of 15 key strokes.
-Make sure that you program a Macro on a spare key that you don’t use in any mode (e.g. A, B, C, D keys).
-Once you program a Macro on a specific key, the sequence will work regardless of the mode you are using.
-If you had to hold down a key for a few seconds on the original remote control to get a function, this function may not work in a macro on your
To erase a Macro
Example. To erase the Macro from the A key, press:
SETUP* | 9 9 5 A key SETUP* |
* Here you must hold down SETUP until the red light blinks twice.
24