AMX R-2 manual Persistent Serial Commands

Programming The Mio R-2

Persistent Serial Commands

There are a select number of persistent commands the Mio R-2 recognizes. Establish a HyperTerminal session with your device to use the following commands:

Serial Commands

@BRT	Set Brightness level
	Syntax:
	"'BRIT-<awake brightness level>,<sleep brightness
	level>'"
	Variables:
	brightness level # = a value from 0 - 32.
	"'@BRT-#'"	(Set LED Awake brightness level)
	"'@BRT-#,#'"	(Set LED Awake brightness level, sleep brightness level)
	Example:
	(1) "'@BRT-16'"
	Sets the awake brightness level to 50%.
	(2) "'@BRT-32,5'"
	Sets the awake brightness level to 100% and sleep brightness level to
	approximately 15%
IRMODE #	Sets the IR transmission frequency to either 455KHz or 38KHz.
	Syntax:
	"IRMODE #"
	Variables:
	# = 455 or 38
	Example:
	"IRMODE 455"
	Sets the IR transmission frequency to 455KHz.
SLEEP-#	Force the device into screen saver mode.
	Syntax:
	"'SLEEP-#'" (timed sleep; a persistent command)
	Variables:
	# = 0 - 60 in seconds; time to wait before going to sleep. Default is 30. 0 sets
	the device to never sleep.
	Example:
	SEND_COMMAND Panel,"'SLEEP-45'"
	Forces the device into screen saver mode after 45 seconds.

12 Mio Modero R-2