AMX R-2 manual Installing The Rechargeable Battery, Screw Points of The Back Housing

Page 21

Mio Remote Charging Base

Installing The Rechargeable Battery

1.Flip and turn the Mio R-2 so that the buttons are facing away from you and the device is upside down.

2.Holding the device in both hands, place your thumbs on the battery door and push up to slide the battery door free.

3.If present, remove AAA batteries.

4.Remove the 6 screws shown in FIG. 7.

6 Screw Points

FIG. 7 6 Screw Points of The Back Housing

5.Remove the back housing.

6.Place the new housing on the device so that the rechargeable battery port connection is now accessible. See FIG. 8.

7.Replace the 6 screws.

8.Connect the terminal end of the Lithium Ion battery to the port shown in FIG. 8. It may be necessary to use a thin, blunt object to fully seat the battery connector within its port.

Lithium Ion Battery

Rechargeable

Battery

Port Connection

FIG. 8 Rechargeable Battery Port on The Mio Remote

Mio Modero R-2

15

 

 

Image 21
Contents Mio Modero R-2 AMX Limited Warranty and Disclaimer Software License and Warranty Agreement Page Table of Contents Table of Contents Mio Modero R-2 Mio Modero R-2 OverviewTouch And Tilt Sensor FCC compliance Overview Mio Modero R-2 Installing Your Custom Buttons Mio R-2 SetupBattery Low Indicator Inserting Batteries into The Mio R-2Mio R-2 Setup Mio Modero R-2 Programming The Mio R-2 Using Connector Ports on The Mio R-2IR/RF Code Matrix IR/RF Code MatrixConfiguration Mode IR Transmit ModeTimeout Adjustment Debug Mode Download ModeBattery Type LED Sleep Mode BrightnessClick Query for Devices Updating Mio R-2 FirmwareSerial Commands Persistent Serial CommandsMio-RCC Charging Base Mio Remote Charging BaseMio Remote Charging Base Top and Bottom view SpecificationsScrew Points of The Back Housing Installing The Rechargeable BatteryCharging The Mio Remote with Charging Base Changing Battery ModesMio Remote Charging Base Mio Modero R-2 It’s Your World Take Control