Universal Electronics DVR 5, PVR 5, PVR 5-DEVICE manual Checking the Codes

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 25

5.Press SETUP once to lock in the code. The TV key will blink twice.

6.To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate key (e.g., AUX, DVD, AUD, or CBL) for the device you are searching for.

CHECKING THE CODES

If you have set up the Atlas DVR/PVR 5-Device Universal Remote Control using the Searching For Your Code procedure (on the previous page), you may need to find out which four-digit code is operating your equipment.

For example, to find out which code is operating your TV:

1.On the remote control, press TV once; it will blink once. Then press and hold SETUP until

the TV key blinks twice, then release SETUP.

2. Enter 9 - 9 - 0. The TV key will blink twice.

3. To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of times the TV key blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box on page 11.

NOTE: If a code digit is “0”, the selected mode key will not blink.

4. Repeat step 3 three more times for the remaining digits. Use 2 for the second digit,

3for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes on page 11.

5.To check for other device codes, repeat steps

1through 4, but substitute the appropriate key (e.g., AUX, DVD, AUD, or CBL) for the device you are checking. Write down the codes in the appropriate boxes on page 11.

25