Programming ID Lock

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 27

The Atlas DVR/PVR 5-Device Universal Remote Control is locked at the factory to operate a Scientific Atlanta cable converter. However, if you have another brand or model of cable converter or satellite service that you would like to control, then you’ll need to perform the fol- lowing steps to unlock the ID Lock, enter in a new manu- facturer’s code, and lock the ID Lock again.

1.Turn on the cable converter.

2.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice, then release SETUP.

3. Enter 9 - 8 - 2. The CBL key will blink four times, indicating ID Lock is unlocked.

4.Perform the instructions in Programming Device Control on page 10 to program device control for the desired cable converter or satellite receiver. Upon completion, perform the remaining steps (5 and 6 on this page) to again lock the ID Lock.

5.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until

the CBL key blinks twice, then release SETUP.

6. Enter 9 - 8 - 2. The CBL key will blink twice, indicating ID Lock is again locked.

PROGRAMMING “TUNE-IN” KEYS FOR SPECIFIC CHANNELS

The Atlas DVR/PVR 5-Device Universal Remote Control includes three “Tune-In” keys (located directly below the MUTE and LAST keys). Each can be programmed to remember three of your favorite cable channel settings for a total of nine channels. If you want to change the cable channels in a previously-programmed “Tune-In” key, you’ll need to clear the key first (see next page).

continued on next page...