Universal Electronics PVR 5-DEVICE RE-ASSIGNING Device Keys, To Re-Assign Perform Key Sequence

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 30

RE-ASSIGNING DEVICE KEYS

The Atlas DVR/PVR 5-Device Universal Remote Control can be set up to control a second device. For example, to have the unit control a TV, a Cable Converter, and two DVD Players, you will need to re-assign the unused AUX key to operate the second DVD Player as follows:

NOTE: AUX is preset at the factory to control an RCA VCR. Performing the below steps will overwrite those settings.

1.On the remote control, press AUX once; it will blink once. Then press and hold SETUP until

the AUX key blinks twice, then release SETUP.

2. Enter 9 - 9 - 2. The AUX key will blink twice.

3. Press DVD once, then press AUX once. The AUX key will blink twice.

4.The AUX key is now ready to be programmed for your second DVD player. See Programming Device Control on page 10.

To re-assign other device keys, repeat steps 1 to 4 and substitute the key sequence using the following chart:

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign	Perform Key Sequence
AUX as 2nd AUD key:	AUX - SETUP - 9	- 9	- 2	- AUD - AUX
AUX as 2nd TV key:	AUX - SETUP - 9	- 9	- 2	- TV - AUX
AUX as 2nd CBL key:	AUX - SETUP - 9	- 9	- 2	- CBL - AUX
AUX back to AUX:	AUX - SETUP - 9	- 9	- 2	- AUX - AUX

To re-assign another unused device key, substitute it for the AUX key above and then perform the sequence. For example, to re-assign an unused AUD key as a second DVD key, perform AUD - SETUP - 9 - 9 - 2 - DVD - AUD.

When a re-assignment is done, the selected device key (e.g., AUD) will blink twice to confirm your choice. At that time, you will need to program device control (see Programming Device Control on page 10).

30