Universal Electronics DVR 5, PVR 5 Using the Master Power KEY, To Program The Master Power Key

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 29

USING THE MASTER POWER KEY

The Atlas DVR/PVR 5-Device Universal Remote Control has a unique feature that allows you to sequentially turn on or off up to five of your home entertainment devices with a single key press.

To Program The Master Power Key:

1.On the remote control, press and hold SETUP until the last-selected device key blinks twice, then release SETUP.

2. Enter 9 - 9 - 5. The last-selected device key will blink twice. Then press PWR once.

3.For the first device you want in the power on sequence, press a device key (e.g., CBL) once .

4.Repeat step 3 up to four more times to add the second,third,fourth,and fifth device,as desired.

5. To save the settings and exit the program, press and hold SETUP until the last-selected device key blinks twice, then release SETUP.

To Operate The Master Power Key:

NOTE: If MASTER POWER is not programmed, pressing it will only command the last-selected device to power on or off.

1.After programming, point the remote control at the devices.

2. Press and hold PWR for at least 2 seconds. You will see the devices power on or off according to the programmed sequence.

To Clear The Master Power Key:

1.Perform steps 1 and 2 in the first section above, To Program The Master Power Key.

2. To clear the settings and exit the program, press and hold SETUP until the last-selected device key blinks twice, then release SETUP.

29