Shifted Learning:
To install a Shifted learning function, simply follow steps 1 – 8 on the previous page, only press the SET key before step 5.
To access the shifted function, press the SET key and then the key you have learned on.
To delete a learned function:
1Press and hold the SET key until the red light blinks twice. The red light will blink once then twice.
2Press 9 7 6 (the red light blinks twice).
3Press the device key in which the function will be deleted.
4Press twice on the learned key which will be deleted. (*)
5If there is another key that you want to delete, repeat steps 1 – 4.
6The original functions of the TOTAL CONTROL will now be present.
(*)To delete a Shifted Learned function, press the SET key once before you press the learned key to be deleted.
To delete all learned functions across all modes:
1Press and hold the SET key until the red light blinks twice. The red light will blink once then twice.
2Press 9 8 0 (the red light will blink four times).
-During steps 2 – 7 (page 12), you have approximately 10 seconds to conduct each step. If there is a gap of more than 10 seconds between two steps, you will have to start again from step number 2.
-If you learn a function on another key besides the ”A - F keys”, the original TOTAL CONTROL feature automatically becomes shifted. Press the SET key then the key to access it (this excludes the POWER, Mute, Channel and Volume keys.
-The learning feature is mode specific. Therefore you can place one learned function per mode on the same key.
-If a Shifted Learned function is placed on the Mute, Channel and Volume keys then the "Auto Scan" and "Colour & Brightness features will be sacrificed.
-The TOTAL CONTROL can learn approximately 25 functions.
-You can replace a learned function by placing another learned function on top.
-Learning should not be done in direct sunlight or under incandescent lights.
-Make sure you are using new batteries before following the instructions above.
-Upon changing the batteries, your learned functions will be retained.
13