External Synced Bridged CONNECTIONS/SETTINGS

EXTERNAL SYNCED BRIDGED CONNECTIONS/SETTINGS

1.Input/Output Signal - Connect these RCA jacks as described in the Front Panel Connection/Controls section of this guide.

2.Remote Sub Level Control - Connect the Remote Sub Level control to the 1100.5 only. The 1100.5 control panel subwoofer adjustments are used first to set the overall gain for all synced amplifiers, then the Remote Sub Level control can adjust the gain of all synced ampli- fiers by adjusting its control knob.

3.Signal Connection - Connect an RCA cable between the BRIDGE OUT jack of the 1100.5 and the SLAVE IN jack of the slaved d600.1 as shown in Figure 6.

4.Slave/Master Switch - Set the slave/master switch of the slaved d600.1 to the slave position. This will put the I/O RCA jack in the SLAVE IN mode so it will accept the

audio signal from the 1100.5’s sync out RCA jack.

NOTE:

There is only one master when syncing amplifiers.

5.Subwoofer Speaker Connection - In this amplifier combination the subwoofer output terminals of both amplifiers drive a common subwoofer load. Use the speaker connection diagram in Figure 6 when connecting the subwoofers to the amplifiers. Connect the ampli- fier’s speaker terminals to any combination of one or more subwoofers that results in a nominal impedance between 2 and 4 ohms. DO NOT connect loads of less than 2 ohms when connecting to amplifiers in the External Synced Bridged combination.

WARNING: Two wires of 12AWG minimum must be connected between the negative sub out termi- nals of the master and slave amplifiers.