Viper manual External Sync Bridged d600.1/1100.5

Page 18

FIGURE 6—EXTERNAL SYNC BRIDGED d600.1/1100.5

Master (1100.5)

1	Do Not Use

1+2	3+4		SUB	1-4 OUT

R

SUB OUT

SYNC

OUT

POWER

	L	BRIDGE		REMOTE
		BRIDGE
		OUT	PROTECTION	2
		OUT

3

Slave (d600.1)

MINMAX

SUB LEVEL

INPUT	I/O	SLAVE
		SLAVE

RSLAVE IN SYNC OUT

L	BRIDGE OUT

MASTER

REMOTE

Do Not Use

4

Do Not Use

Speaker Wiring (bottom view)

Sub

5

NOTE:	The dual + and -- subout terminals of the d600.1/1100.5 are paralleled internally and
	the combined load impedance should be taken into consideration when connecting
	multiple subwoofers.

18	© 2002 Directed Electronics, Inc

Image 18

Contents Model Directed Electronics, Inc Table of Contents CongratulationsLimited TWO-YEAR Consumer Warranty Features „ Summed stereo full-range RCA output jacksInstallation Guidelines Wire Connector Plugs Cut wires to the minimum length necessaryFront Panel CONNECTIONS/STATUS LED Amplifier Connections 1100.5 FrontRear Panel Connections Amplifier Connections 1100.5 RearTOP Panel Controls Amplifier Controls TOP Illuminated Window Alignment TOP Panel FeaturesControl Panel Cover Viper Badge MountingSpeaker Wiring Diagrams Parallel Synced Gain Combined Amplifiers Gain and Filter SettingsCombined Amplifiers External Synced BridgedParallel Synced Gain CONNECTIONS/SETTINGS Speaker Wiring bottom view MasterSlave d600.1 External Synced Bridged CONNECTIONS/SETTINGS Audio signal from the 1100.5’s sync out RCA jackExternal Sync Bridged d600.1/1100.5 Crossover Settings and Gain Adjustment Ch 1-4 Ch SpecificationsViper model Watts watts 125 250x2Page Directed Electronics, Inc Vista, California Company behind this system is Directed Electronics, Inc