Viper manual Front Panel CONNECTIONS/STATUS LED, Amplifier Connections 1100.5 Front

Page 8

FRONT PANEL CONNECTIONS/STATUS LED

1.RCA Input Jacks - Accepts line level outputs from head units or signal processors between 150mV and eight volts.

2.RCA Sub Input Jacks - Accepts line level outputs from head units or signal processors between 150mV and eight volts for the subwoofer section of the amplifier.

3.RCA Output Jacks - These pass through RCA jacks can be used to send a signal to a second amplifier. It is the summed stereo output of the one through four channel inputs of the amplifier.

4.RCA Sync Out Jack - This RCA jack sends a synced, or in-phase, gain matched signal to a d600.1 slave amplifier when connected in the Parallel Synced Gain combination. (Refer to the Combined Amplifiers section of this guide.)

5.RCA Bridge Output Jack - This output sends an out-of-phase signal to a d600.1 slave amplifier when connected in the External Synced Bridged combination. (Refer to the Combined Amplifiers section of this guide.)

6.Status LEDs - The Power LED will light GREEN to indicate the amplifier is on and operating normally. The GREEN LED will turn off and the Protection LED will light RED when the amplifier has shut itself down due to speaker short circuit, DC offset or overheating.

7.Remote Sub Level Control - Controls the subwoofer amplifier gain controls from a remote location for ease of adjustment during listening.

Warning: DO NOT connect a level control knob from other manufacturers to the Remote Sub Level Control of any Viper amplifier. Even though the connectors fit properly, the control knob and connector pin posi- tions may be different and the amplifier will be damaged.

FIGURE 1—AMPLIFIER CONNECTIONS 1100.5 FRONT

1

2

3

4

5

6

7

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

8

© 2002 Directed Electronics, Inc

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Model Directed Electronics, Inc Table of Contents CongratulationsLimited TWO-YEAR Consumer Warranty Features „ Summed stereo full-range RCA output jacksInstallation Guidelines Wire Connector Plugs Cut wires to the minimum length necessaryFront Panel CONNECTIONS/STATUS LED Amplifier Connections 1100.5 FrontRear Panel Connections Amplifier Connections 1100.5 RearTOP Panel Controls Amplifier Controls TOP TOP Panel Features Control Panel CoverIlluminated Window Alignment Viper Badge MountingSpeaker Wiring Diagrams Combined Amplifiers Gain and Filter Settings Combined AmplifiersParallel Synced Gain External Synced BridgedParallel Synced Gain CONNECTIONS/SETTINGS Slave d600.1 Speaker Wiring bottom viewMaster External Synced Bridged CONNECTIONS/SETTINGS Audio signal from the 1100.5’s sync out RCA jackExternal Sync Bridged d600.1/1100.5 Crossover Settings and Gain Adjustment Specifications Viper modelCh 1-4 Ch Watts watts 125 250x2Page Directed Electronics, Inc Vista, California Company behind this system is Directed Electronics, Inc
Top Page Image Contents