Viper 1100.5 manual Master, Slave d600.1, Speaker Wiring bottom view

Page 16

FIGURE 5—PARALLEL SYNC GAINED d600.1/1100.5

Master (1100.5)

1	Do Not Use

1+2	3+4	SUB	1-4 OUT SUB OUT
R			SYNC
R			OUT
			OUT
L			BRIDGE
L			OUT
			OUT

3

Slave (d600.1)

POWER

REMOTE

PROTECTION

2

MINMAX

SUB LEVEL

INPUT	I/O	SLAVE
		SLAVE

RSLAVE IN SYNC OUT

L	BRIDGE OUT

MASTER

REMOTE

Do Not Use

4

Do Not Use

Speaker Wiring (bottom view)

Sub

5

NOTE:	The dual + and -- subout terminals of the d600.1/1100.5 are paralleled internally and
	the combined load impedance should be taken into consideration when connecting
	multiple subwoofers.

16	© 2002 Directed Electronics, Inc

Image 16

Contents Model Directed Electronics, Inc Table of Contents CongratulationsLimited TWO-YEAR Consumer Warranty Features „ Summed stereo full-range RCA output jacksInstallation Guidelines Wire Connector Plugs Cut wires to the minimum length necessaryFront Panel CONNECTIONS/STATUS LED Amplifier Connections 1100.5 FrontRear Panel Connections Amplifier Connections 1100.5 RearTOP Panel Controls Amplifier Controls TOP TOP Panel Features Control Panel CoverIlluminated Window Alignment Viper Badge MountingSpeaker Wiring Diagrams Combined Amplifiers Gain and Filter Settings Combined AmplifiersParallel Synced Gain External Synced BridgedParallel Synced Gain CONNECTIONS/SETTINGS Master Speaker Wiring bottom viewSlave d600.1 External Synced Bridged CONNECTIONS/SETTINGS Audio signal from the 1100.5’s sync out RCA jackExternal Sync Bridged d600.1/1100.5 Crossover Settings and Gain Adjustment Specifications Viper modelCh 1-4 Ch Watts watts 125 250x2Page Directed Electronics, Inc Vista, California Company behind this system is Directed Electronics, Inc