CHECKING THE CODES
If you have set up the Polaris Remote Control by searching for your device code (on the previous page), you may need to find out which
1.On the remote control, press TV once; it blinks once. Then press and hold SETUP until the TV key blinks twice.
2.Enter 9 9 0. The TV key blinks twice.
3.To view the code for the first digit, press 1 once. Count the number of times the TV key
blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box on page 13.
NOTE: If a code digit is 0, the selected mode key does not blink.
4.Repeat step 3 three more times for the remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code boxes on page 13.
PROGRAMMING ID LOCK
The Polaris Remote Control is locked at the factory to operate your cable system’s cable converter. However, if you have another brand or model of cable converter that you would like to control, then you’ll need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.
www.urcsupport.com
14