4.Press CBL once, followed by the channel number to be programmed (e.g., 3 9 for channel 39).
NOTE: If you are programming a channel for a Digital Cable Converter, you need to enter all channels in a
0 3 9.
5.Press and hold SETUP until the CBL key blinks 
twice.
6.To add another channel, repeat steps 1 through 5, substituting the new channel to be added in step 4.
NOTE: Programming more than five channels on the VOD key overwrites previous settings.
Clearing the VOD Key
1.On the remote control, press CBL once; it blinks once. Then press and hold SETUP until the CBL key blinks twice.
2.Enter 9 9 5. The CBL key blinks twice.
3.Press VOD once.
4.Press and hold SETUP until the CBL key blinks 
twice.
The VOD key is now clear and ready for reprogramming (see “Programming the VOD Key.” on page 16).
www.urcsupport.com
17