CHECKING THE CODES
If you have set up the Cogeco Atlas DVR
For example, to find out which code is operating your TV:
1.On the remote control, press TV once; it will blink once. Then press and hold SETUP until
the TV key blinks twice, then release SETUP.
2. 
Enter 9 - 9 - 0. The TV key will blink twice.
3. 
To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of times the TV key blinks (e.g., 3 blinks = 3) and write down the number in the leftmost TV Code box on page 11.
NOTE: If a code digit is “0”, the selected mode key will not blink.
4. 
Repeat step 3 three more times for the remaining digits. Use 2 for the second digit,
3for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes on page 11.
5.To check for other device codes, repeat steps
1through 4, but substitute the appropriate key (e.g., AUX, DVD, AUD, or CBL) for the device you are checking. Write down the codes in the appropriate boxes on page 11.
14