Universal Electronics DVR M1055F manual Changing Volume Lock, RE-ASSIGNING Device Keys

RE-ASSIGNING DEVICE KEYS (continued)

To Re-Assign	Perform Key Sequence
AUX as 2nd AUD key:	AUX - SETUP - 9 - 9	- 2	- AUD - AUX
AUX as 2nd TV key:	AUX - SETUP - 9 - 9	- 2	- TV - AUX
AUX as 2nd CBL key:	AUX - SETUP - 9 - 9	- 2	- CBL - AUX
AUX back to AUX:	AUX - SETUP - 9 - 9	- 2	- AUX - AUX

To re-assign another unused device key, substitute it for the AUX key above and then perform the sequence. For example, to re-assign an unused AUD key as a second DVD key, perform AUD - SETUP - 9 - 9 - 2 - DVD - AUD.

When a re-assignment is done, the selected device key (e.g., AUD) will blink twice to confirm your choice. At that time, you will need to program device control (see Programming Device Control on page 10).

CHANGING VOLUME LOCK

On this remote control, the volume is unlocked so that you have independent control of each programmed device’s volume controls. If desired, you can still perform Individual Volume Unlock on a selected device to set its volume control for independent operation.

NOTE: The audio mode’s volume controls are active regardless of Volume Lock settings. However, if you lock the volume controls to the AUD mode, you will have control of the audio device’s volume in all other modes (i.e., AUX, DVD, TV, and CBL).

Locking Volume Control To A Specific Device (Individual Volume Unlock):

1.Assuming Global Volume Lock is active, select a mode on the remote control that you want to

unlock (e.g.,CBL) and press it once. Next, press and hold SETUP until the device key blinks twice, then release SETUP.

2. Enter 9 - 9 - 3. The last-selected device key will blink twice.

3. Press VOL- once. The last-selected device key will blink four times.

20