Custom Clock Options, Program Lock | Pentair CP-1000 manual

CUSTOM CLOCK OPTIONS

The standard CP-1000 Controller is provided with six programs plus the "Filter Pump Off" safety delay. Your Pool Builder may, however, have incorporated one or more of the following custom features:

PROGRAM LOCK:

To safeguard against someone accidentally pushing the PROGRAM Button and inadvertently tampering with your daily program, your Pool Builder may have included a Program Lock feature.

In this instance, you will need to push the PROGRAM Button quickly twice in order to put the Clock into Program Mode.

SINGLE OCCURRENCE PROGRAM:

Occasionally, you may wish to use your spa (or other equipment) at a time which is different from your normal daily program. In this instance, it is possible to enter a "once only" program step, which will occur within the following 24 hour period without having to reprogram the daily equipment sequence.

The "once only" program will automatically be canceled once the Clock reaches its next program step. Push PROGRAM Button to put Clock into Program Mode.

"PROG" will appear on the right of the Display. Continue to push PROGRAM Button until a flashing "ONCE" appears.

Enter the time that you wish to activate the spa (11:00 pm in our example) by pushing the HOURS and MINUTES Buttons. Push FILTER Equipment Button.

"ON" will appear directly above FILTER Button. Push PROGRAM Button to lock-inthe program. Remember to manually turn the equipment off after use, otherwise it may run all night until the Clock reaches its next program step.

COUNTDOWN TIMER:

This feature enables you to preset the operating time of any piece of equipment.

Whenever that equipment is turned on (either from the CP-1000 or an optional Remote Control), it will run for a predetermined length of time and then automatically switch off.

The countdown duration can range from a minimum of 10 minutes to a maximum of 11 hours and 50 minutes (in ten minute increments).

To better understand this feature, let us look at a typical application:

For example, we are using AUX 3 to activate the jet pump, and we would like the jets to run for a period of 30 minutes whenever they are activated.

Push PROGRAM Button to put Clock into Program Mode. "PROG"will appear on the right of the Display. Continue to push PROGRAM Button until a flashing "TIMER" appears.

Enter the desired countdown duration (30 minutes in our example) by pushing the HOURS and MINUTES Buttons.

Push appropriate Equipment Button (AUX 3 in our example). "ON" will appear directly above Equipment Button.

Push PROGRAM Button to lock-in the program.