EQUIPMENT CONTROL:
The Controller houses a 24 hour Clock with a digital display, which is used to program daily filtration cycles and auxiliary equipment (suchas pumps and lights).
There are five Equipment Buttons which are used for switchingthe pool equipment ON or OFF: FILTER Button: Activates filter pump, and circulates water through the filtration and heatingsystem.
Enables water to be heated.
AUX 1 Button: Activates auxiliary 1 equipment (such as spa light or pool cleaner).
Note: If pool cleaner is used, it will be delayed for 4 minutes whenever it is activated, and
it will also automaticallyactivate the filter pump (even if FIIXER Button is not switched ON).
See "POOLCLEANER PROTECTION"(Page 3).
AUX 2 Button: Activates auxiliary 2 equipment (such as a fountain),
AUX 3 Button: Optional. Activates auxiliary 3 equipment (such as jet pump or waterfall).
AUX 4 Button: Optional. Activates auxiliary 4 equipment (such as landscape lights). Note: The daily operation of this equipment cannot be programmed.
The PROGRAM, HOURS and MINUTES Buttons are used for setting the Clock, and for programming the daily operation of the FILTER, AUX 1, AUX 2, and AUX 3. See Page 6.
The DELAY CANCEL Button is used to override the "Pool Filter Pump Off Delay" and optional "Pool Cleaner On Delay" circuits (for testing and servicing purposes only).
Status Lights are provided for the various pieces of equipment controlled by the
The presence of a light indicatesthat the equipment has been activated. The absence of a light indicatesthat the equipment is turned off.
'TEMPERATURECON'TROL:
HEAT SOURCE Switch:
It is possibleto heat you spa or swimming pool using solar energy, conventional heat, or a combination of both. However, no heatingwill take place unless the filter pump is running:
SOLAR Position: | Allows heating with solar only. |
| Allows preferential heating with solar, but automatically switches to conventional heating |
HEATER Position: | when solar energy is unavailable. |
Allows heating with gas or electric heater only. | |
| Note: If you are heatinga swimming pool, your Pool Builder may have modified the Controller |
| so that the solar system will also contribute to the conventional heat whenever solar energy is |
OFF Position: | available. |
Allows no heating. |
SOLAR ON Light: lndicateswhenever solar system is on.
HEATER ON Light: Indicateswhenever gas or electric heater is on.
THERMOSTAT Dial:
Used to preset your desired water temperature.
As long as HEAT SOURCE Switch is not in the "OFF position, the water will heat up to the preset temperature whenever the filter pump is running.
Temperature Display:
Whenever the filter pump is running, the precise water temperature will be displayed in degrees Fahrenheit.
Note: Filter pump must be running in order to provide accurate temperature display.