Contents, Assembly, Drive shaft/power head

Bed Redefiner 9

Operator's Manual

The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, some assembly may be necessary.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.

___ 1, Power Head

___ 1, Drive Shaft Assembly

___ 1, Plastic Bag (Co-Pack)

___ 1, Operator's Manual

___ 1, Safety Manual

___ 1, Warranty Registration Card

___ 1, Support Handle

___ 1, Lower Bracket, Support Handle

___ 4,	5 x 35 mm screws
___	Assembly Tool (s)
___ 2,	Split pin
___ 1,	8 x 10 mm Spanner Wrench
___ 1,	Safety Glasses

Assembly

Parts Required: Power head, Drive Shaft Assembly

drive shaft/power head

1.Stand power head upright on a level surface.

2.Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft clamp, and remove center drive shaft location bolt (A).

3.Remove dust cap and carefully fit drive shaft assembly to engine making sure that inner drive shaft engages into clutch mount.

4.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (A).

NOTE

Gear Housing must be aligned properly with engine. Aligning cen- ter locating hole in driveshaft housing with center drive shaft bolt

(A) provides correct alignment.