Searching for Codes

1.Turn on the device you want to control.

2.Press and hold SETUP until the LED indicator lights steadily. Release Setup button.

3.Press the mode button that matches the equipment you want to control The LED blinks once.

4.Press CH + repeatedly* until the device to be controlled changes channel.

If you go past the code accidentally, just press LAST repeatedly until the channel changes again.

5.Press and release the ENTER button to

complete the setup.

*Note: You may have to press CH + many times (50+). If the device does not have a Channel Up function, use the PLAY button (VCR only) or the POWER button.

IDENTIFYING CODES FOUND USING THE SEARCH PROCEDURE

1.Press and hold SETUP until the LED indicator lights steadily. Release Setup button.

2.Press the mode button that matches the equipment you want to identify The LED blinks once.

3.Press and release SETUP. The LED

blinks once.

4.To find the first digit, press each number button from 0 to 9 until the LED blinks. The number you pressed is the first digit of the code.

5.Press each number button from 0 to 9 again as above to find the second digit.

6.Press each number button in turn to find the third digit. When the third digit has been found, the LED will go out.