X10 Wireless Technology UR24A owner manual Controlling Modules, To SET the X-10 Sleep Timer

CONTROLLING X-10

MODULES

If you have already installed the Transceiver Module, you can control it and other X-10 modules as follows:

1.Press and release the X-10 button.

2.Use the number buttons to enter the Unit Code number of the chosen module. (You do not need to enter ‘0’ first for a single digit number.)

3.Press the appro- priate button for the function you require (see below).

X-10 FUNCTIONS:
On:	CHANNEL +
Off:	CHANNEL –
Bright:	VOLUME +
Dim:	VOLUME –
All Lights On:	POWER
All Modules Off:	MUTE

Note: You cannot dim or brighten an Appliance Module. If the module was off and you press Bright or Dim (VOLUME+ or VOLUME-) this will simply turn the module on.

TO SET THE X-10 SLEEP TIMER

The X-10 Sleep Timer switches off the chosen modules after the preset time.

1.Press and release the X-10 button.

2.Press and hold TIMER until the LED indicator lights steadily. Release TIMER button.

3.Use the number buttons to enter the module Unit Code for the module to be turned off.

4.Press the desired function button (e.g. CH - to turn the module off after the preset time).

5.Using the number buttons enter the sleep time required (1 to 99 mins).

6.Press ENTER to confirm the setting.

CHANGING THE X-10 HOUSE CODE:

The Learning SuperRemote defaults to House Code A, and in most cases you will not need to change this unless you are experiencing interference from a neighboring X-10 system.

1.Press and release the X-10 button.

32 33