Crisp Solutions UCommand-525 Toggling the Beep Signal On/Off, Recalling the Original LCD Layout

Page 35

— Operating the UC-525

Toggling the Beep Signal On/Off

This function toggles the beep signal off and on. To turn off the beep signal, press the active device button (or press any device button twice). To turn it back on, press the active device button again.

UC-525

Figure 3-2: Turning off the beep signal

Recalling the Original LCD Layout

You can reset the LCD panel buttons to their original factory con- figuration. Any configuration changes you have made will be lost.

The learned codes are not deleted; to delete those, refer to “‘Using the Delete Function”

To recall the original LCD layout, press the TV and DVD device but- tons at the same time for five seconds:

31

Image 35

Contents User’s Guide Preface Table of Contents Frequently Asked Questions Introducing the UC-525 Unpacking the UC-525 UC-525 FeaturesIR Port Identifying ComponentsGetting Started Power SupplyBattery low icon UC-525 User’s Guide Turning the LCD on LCD Touch Screen ButtonsTouch screen precautions UC-525 LCD panel layout UC-525 ButtonsOperating the UC-525 Before using the Learning FunctionUsing the learning eye Using the Learning FunctionUC-525 User’s Guide First See Using the Delete Function Deleting a command button Delete button Exit Delete Function Changing the LCD Layout UC-525 User’s Guide Macro Function Changing the AUX Device LayoutMacro setup Time Delays between macro commands Macro example Press the TV button UC-525 User’s Guide Running the macro Adjusting the LCD BacklightUC-525 User’s Guide Operating the UC-525 UC-525 Recalling the Original LCD Layout Toggling the Beep Signal On/OffRecalling the original LCD panel configuration Power saving UC-525 SpecificationsSymptom Remedy TroubleshootingAppendix BB UC-525 User’s Guide Through volume Frequently Asked QuestionsUC-525 User’s Guide Button X10 Function Pre-configured X10 CodesAppendix E UC-525 Universal LCD Remote Control User’s Guide