Crisp Solutions UCommand-525 manual Appendix BB

	— Appendix BB
	∙ Make sure you have fresh batteries. With weak
	batteries the UC-525 may have learning prob-
	lems.
The UC-525 does	∙ Point the original remote to the bottom of the
not react to button	UC-525. The learning eye is at its bottom.
presses of the
original remote in
learning mode
You see an “error”	∙ Try the learning procedure again. Repeated
display during the	“error” messages probably indicate that the
learning proce-	UC-525 does not recognize the particular IR
dure.	code.
You see an “error”	∙ The button that you pressed has not been con-
display during	figured. Configure the button using the
operation.	learning procedure.
The RECORD	∙ A feature of the UC-525 prevents the record
button does not	function of your Tape or VCR from starting un-
work	intentionally. Hold the RECORD button for
	about 2-3 seconds for the command to be sent
	to the VCR.
Problems learning	∙ Some remotes return a confirmation signal
from 2-way re-	from the device, which can confuse the learn-
motes	ing capability. The device should be prevented
	from sending this signal during the learning
	procedure. Turn off the device while program-
	ming, or go to another room. Alternately, move
	The UC-525 out of the line-of-sight of the de-
	vice immediately after programming a button.
Problems learning	∙ Delete the IR code for the respective button
repetitive com-	and try learning it again by holding the volume
mands, such as	button on the original remote until you see the
Volume Control	“OK” icon.
	∙ Delete the IR code for the respective button
	and try learning it again by pushing the volume
	button on the original remote control only
	briefly.
Problems learning	∙ See Appendix E
sound field com-
mands from
SONY Amplifiers

35