Hitachi 50V720 How to set up your new Hitachi Projection Television, Antenna, Location, Viewing

Page 5

How to set up your new HITACHI Projection Television

ANTENNA

Unless your LCD Rear PTV is connected to a cable TV system or to a centralized antenna system, a good outdoor TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set. To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc. When using your LCD Rear PTV against a wall, keep it at least 10cm (4 inches) from the wall.

NOTE: Your new HDTV has a built-in high definition television signal processor. This television includes a fan to cool the processor. The sound of moving air from the fan is normal and may be noticeable in very quiet environments.

First time use

VIEWING

The major benefit of the HITACHI LCD Rear PTV is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

 

 

 

BEST

 

 

 

20

VERTICAL VIEWING

 

 

ANGLE

 

 

3'

 

 

 

0'

5'

10'

15'

20'

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

R

 

 

 

S

 

 

20'

 

 

 

 

 

4" Minimum

50

BEST

 

 

 

 

 

 

 

 

HORIZONTAL

 

5'

 

10'

15'

20'

 

50

VIEWING ANGLE

 

4" Minimum

 

 

 

 

 

 

 

L

 

 

 

S

IMPORTANT NOTES:

1.Since LCD Rear PTV incorporates a high pressure lamp to display an image, it may take about one minute for the picture to become stable, after the power has been turned on. After extended use, the picture may darken, the color may look unusual, or the lamp “goes out,” (burns out). You may hear a “pop” sound when the lamp “goes out.” These are common characteristics of the lamp, and should not be considered defective.

2.LCD Rear PTV incorporates an advanced cooling fan system to prevent from overheating. If you hear the cooling fan, it should not be considered defective.

3.If you hear a “cracking” sound from the TV cabinet, it is due to the TV’s cabinet expanding and contracting due to room temperature changes. It has no effect on the TV’s functions.

4.The LCD Rear PTV cabinet is constructed with all plastic. Make sure to place it on a flat surface. An uneven surface might warp the cabinet and reduce the picture quality.

5

Image 5
Contents Lamp Replacement Important Safety Instructions First Time USE Remote ControlON-SCREEN Display Useful InformationRead Before Operating Equipment Important Safety InstructionsModifications Power sourcePublic viewing of copyrighted material Lead NoticeRemote Control Battery Installation and Replacement AccessoriesAntenna How to set up your new Hitachi Projection TelevisionLocation ViewingAntenna Connections to Rear Jack Panel Hook-up Cables and ConnectorsQuick Reference Remote Control Buttons and Functions Side Input Jacks Input Front Panel ControlsLamp Indicator Power LightTemp Indicator Side Panel Jacks and Connections Rear Panel Connections CableCARD Slot TV AS Center InputsCableCARD Information and press the Select button Additional CableCARD InformationUse the Cursor button VIDEO,Y-PBPRand Hdmi Tips on Rear Panel ConnectionsSpeaker placement Connecting External Video SourcesBefore Operating External Video Source FirstConnecting a Composite Video Approximately four seconds InputConnecting a Component Remote Control Mode buttons How to Use the Remote to Control Your TVPause button DAY/NIGHT buttonStandard Aspect buttonExpanded ZOOM1/ZOOM2PICTURE-IN-PICTURE button Inputs buttonMenu button Exit buttonWhite Channel CH DownPicture-in-Picture PIP POP Mode Picture-in-PicturePIP button SUB PictureSplit Mode Picture-in-Picture PIP Mode Picture-in-PictureSurf Mode Picture-in-Picture Picture-In-Picture PIP ModesStrobe Freeze Main FreezeSplit Freeze Cable Brand Codes Remote Control for Cable Box FunctionsOperating the Precoded Function for Your Cable BOX Satellite Brand Codes Remote Control for Set-Top Box/Satelite Receiver FunctionsSET TOP BOX Brand Codes MY Satellite ReceiverDVD Brand Codes Remote Control for DVD FunctionsOperating the Precoded Function for Your DVD Player VCR Brand Codes Remote Control for VCR FunctionsOperating the Precoded Function for Your VCR On-Screen Display DRC SRSBBE Video Aspect Mode Black Side Panel Reset Video SettingsVertical Position BBE AudioSRS Perfect Volume Auto Noise CancelAudio Source Internal SpeakersDigital Output LanguagePCM DRCChannel Manager Signal MeterSignal Meter Auto Channel Scan Start or Reset optionCable or AIR Channel ListLocks Change Access CodeNot Rated Movie RatingsMotion Picture Ratings Table TV Parental Guide Ratings Table TV RatingsCanadian Ratings English Table Canadian Ratings EngCanadian Ratings French Chart Set The Clock TimersAdjust Clock for Daylight Savings Set Day/Night Timer Set Sleep TimerEvent 1 , Event 2 , Event 3 , Event 4 and then Set Event TimerSelect Start Time HOUR/MINUTE, AM or Select Finish Time HOUR/MINUTE, AM orSolid SetupSET the Menu Background Shaded or Set The Inputs Lamp Power ControlInput 4 Auto Link Caption ModeSet Closed Caption Caption DisplaySet Monitor Out Digital CaptionsMonitor TV Tuner OutYES ANTHDMI1 YES HDMI1Upgrade NOW UpgradesInsert MMC Card Quick Start UpLamp Life Lamp ReplacementLamp Replacement Lamp Compartment Front Cover 120VLamp Cover ScrewPhillip Head Screw Driver Handle Lamp Unit Remove ScrewsScrew Troubleshooting Equipment Care and TroubleshootingSwitch ON/OFF Do notReception Problems Features Features and SpecificationsDimensions InputsDigital Media Division Home Electronics DivisionCanada 1-800-HITACHI Meadowpine Blvd Mississauga, Ontario L5N 6C3END User License Agreement for Hitachi DTV Software End User Licence Agreement for Hitachi DTV SoftwareImage Input Type Format Aspect Video ID Auto Aspect AppendixesLocks IndexPage Page Page Page Page QR64621