Manual Convergence Adjustment Mode

SETUP

NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.

2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode. DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.

Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.

To Move Adjustment Point

To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED.

To Change the Color of Adjustment Point

Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.

To Adjust the Convergence

Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.

Video

Aspect

Audio

Chan. Manager

Locks

MENU	Setup

Move SEL Sel

Setup

Magic Focus Tune Up

Aligns the Red, Green, and Blue colors to correct for Magnetic Influences.

Adjustment Mode

Auto		At turn off,
Manual		(After 90 days).
Manual

If you want to adjust now Start

Move SEL Return

THUMB	THUMB
STICK	STICK
SELECT

THUMB

STICK

SELECT

THUMB	THUMB
STICK	STICK
	SELECT

Setup

Magic Focus Tune Up

Menu Preference

Set The Clock

Set The Inputs

Set The Color System

Set Virtual HD

Set Black Side Panel

Set Event Timer

Set Closed Caption

About Your TV

Move SEL Select

Adjustment Point

Cursor

ON-SCREEN DISPLAY

If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.

					117 Manual Adjust
					Please Enter Number.
					0.Cancel and go to Normal Mode.
					1.Done and go to Normal Mode.
EXIT					2.Back to Adjust Mode
					3.Factory Reset and
					Back to Adjust Mode.

					0-3.Select

Press the [0] button on the remote control to CANCEL adjusted data and return to main picture. Press the [1] button on the remote control to SAVE adjusted data and return to main picture.

Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern). Press the [3] button on the remote control to recall the factory pre-set convergence data.

Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall the factory pre-set data.