Hitachi 57S700, 65S700, 51S700 Set Monitor Out, Upgrades, ON-SCREEN Display

SETUP

Set Monitor Out

This feature will select the source of the Monitor Output.

Setup

Set Timer Recording

Set Monitor Out

Upgrades

Set Stand-By Mode

Move SEL Return

THUMB

STICK

SELECT

Setup

Set Monitor Out

Monitor Out

Monitor

TV Tuner Out

Move SEL Return

Monitor- Select Monitor to output the audio and video signals of the chosen input source (ANT A, ANT B, VID3-VID5) to a VCR or other A/V device. It will also send digital audio and video signals from ANT C - DTV and IEEE1394 devices that are not copy protected.

TV Tuner Out- Select TV Tuner Out to output the audio and video signals of the last watched Antenna Source (ANT A, AN T B, ANT C).

Use THUMB STICK , to highlight the function to change then press down on THUMB STICK to select the function. Press EXIT to quit menu or THUMB STICK to return to previous menu.

Upgrades

This function only works in ANT C (Digital Signal). It shows software information and easy upgrade procedure. This function allows the TV software to be upgraded by using a flash card (MMC Card). If a future software upgrade is required for your TV, Hitachi will notify and provide you with a flash card. In order to receive written notification and the flash card, please complete and return the warranty card.

Setup

Set Timer Recording

Set Monitor Out

Upgrades

Set Stand-By Mode

Move SEL Return

THUMB

STICK

SELECT

Setup
Upgrades
Software Version:		Main	V00.15
		1394	V00.07
MMC Software Upgrade
	Upgrade Now
Please insert MMC card
	before upgrading.
Move SEL	Select

Insert MMC card, then press THUMB STICK , to highlight “Upgrade Now”. Press down on THUMBSTICK to select and start upgrading.

ON-SCREEN DISPLAY

NOTE: Any power interruption during the upgrade process will cancel the upgrade. When this happens, repeat the upgrade procedure.

Set Stand-By Mode		This function sets the IEEE1394 in Stand-By Mode.
	Setup			Setup
	Set Timer Recording			Set Stand-By Mode
	Set Monitor Out
	Upgrades		THUMB	If you want to use the IEEE1394
				function in the Stand-By, please
	Set Stand-By Mode		STICK
				set the IEEE1394 Stand-By mode.
	Move SEL	Return
			SELECT	IEEE1394 Stand-By

Move SEL Return

72